The best and simplest explanation I have found, thank you for sharing and helping this DIY Brit 🇬🇧
@carl40334 жыл бұрын
Excellent video! Thanks
@umitkumac73133 жыл бұрын
Thanks for your good information
@stephenward25703 жыл бұрын
Very informative.
@PaulyDownUnder3 жыл бұрын
In regards to the corners where the two SIPs join up, would that corner act as a thermal bridge as the EPS insulation does not join together. Can you cut the SIPs at 45 degrees instead, have a piece of steel angle (or similar) on the outside (and maybe inside), which is screwed into the two SIPs panels holding them together and overlap the top plate to give it strength?
@darkfactory80823 жыл бұрын
To me looks like everything you need to know about sips, some special aplications should be adjusted accordingly. =)
@py_tok55893 жыл бұрын
VERY LOVELY, THANK YOU
@roberthunter564 Жыл бұрын
brillant vidio
@Lawiah02 жыл бұрын
1) Structure, 2) Insulation, 3) Air Barrier, 4) Vapor Barrier, 5) Thermal Mass
@GodAmonstGamers Жыл бұрын
if anybody has put sips on a concrete floor can u reply here so i can get some info. currently lifting old concrete and need some info before i put new concrete down
@davidoneill42803 жыл бұрын
Garden room sips
@robinrutschman2 жыл бұрын
14:40 Window Sill Panel NEEDS to be inserted earlier for it to be attached to the Jack Studs. This video is WRONG!!!
@ericrichards7884
2 жыл бұрын
Yes, I noticed that also. Absolutely no reason to jump ahead with the wall panels.
Пікірлер: 13
The best and simplest explanation I have found, thank you for sharing and helping this DIY Brit 🇬🇧
Excellent video! Thanks
Thanks for your good information
Very informative.
In regards to the corners where the two SIPs join up, would that corner act as a thermal bridge as the EPS insulation does not join together. Can you cut the SIPs at 45 degrees instead, have a piece of steel angle (or similar) on the outside (and maybe inside), which is screwed into the two SIPs panels holding them together and overlap the top plate to give it strength?
To me looks like everything you need to know about sips, some special aplications should be adjusted accordingly. =)
VERY LOVELY, THANK YOU
brillant vidio
1) Structure, 2) Insulation, 3) Air Barrier, 4) Vapor Barrier, 5) Thermal Mass
if anybody has put sips on a concrete floor can u reply here so i can get some info. currently lifting old concrete and need some info before i put new concrete down
Garden room sips
14:40 Window Sill Panel NEEDS to be inserted earlier for it to be attached to the Jack Studs. This video is WRONG!!!
@ericrichards7884
2 жыл бұрын
Yes, I noticed that also. Absolutely no reason to jump ahead with the wall panels.