Very clean install. Thanks for making the video.

Just got DRO...going on HD36...your mounting ideas great...tx...with your engineering acumen...how about a vid on a quarter sawing jig...

I have the HM126XL with trailer sitting in the box. No time to work on it right now. I am going to add this to the build this winter. Good job.

Well done LJ, thank you.

Thanks Jack for a very informative and helpful how to video. I also would be interested in what your post installation experience has been. Best.

Doing this right now based on your video. Thank you

Nice Looking Install. I have been wanting to do the same with MY 130 Max.

Waiting to hear how well it works and your final thoughts

I notice you marked the lower slide hole on one side of the pice that holds the rulers, then drilled from the other side. How did you transfer that spot? Enjoy your videos a lot.

Very cool.

I'd be interested to know how it's held up for accuracy and reliability.

It's not called a DRO if you walk into a machine shop and call it a DRO, they will laugh you out of the place. It is referred to as a D.R.O Digital Read Out I'm not even going to continue watching you. BTW, I have been a machinist for over 30 years & I currently have my own shop.

@Lumber_Jack

Жыл бұрын

I used to work in a machine shop back in the late 80s -- we called them "ACU-RITE" or (jokingly) "R2-D2" back then. Nobody used "DRO" or "D.R.O." at all. I think it was almost the same mentality as always calling a milling machine a "Bridgeport". Anyhow, I doubt any of this is universal or even matters, but you gotta stick to your principles here on KZread! 🤣

@bradsmith1046

8 ай бұрын

Perhaps a bit of grace might be in order. Ask your wife, or your children. Jack has done an admirable job of walking regular folks through the D.R.O. installation and should be commended. I will keep an eye out for your KZread channel when it up and running and make certain to point out any failings I see, Even a true master like Joe Pie would be more gracious than you.