Grinding and sanding rust off rims takes forever, I've done it a couple times but it's always a pain and there's usually rust still left in the really hard to reach areas. Sandblasting is a lot more effective if you have access to it, or setting up a little electrolysis tub at home is a good way to lower the amount of work you have to put into getting the rust off. Good job for saving those completely fine rims from the dump

@ManiiZilla

4 жыл бұрын

I realized half way through that there should’ve been an easier way of getting the rust/paint off the surface of the rims rather than grinding them cus yeah ur right the grinding process took forever and a bit of work but thank you for the feedback I appreciate that :) 🙏🏼

@robbierisque

4 жыл бұрын

@@ManiiZilla Sometimes you just gotta work with what you got. I just tried using electrolysis on some rims and it worked but is kind of slow, so I gave up halfway through and just got them sandblasted along with my trailer frame. Thanks for the videos!

@JesusMedrano12

3 жыл бұрын

Have y’all tried using distilled white vinegar? Could try using a rag for hard to reach spots.

@Raymasseyus

3 жыл бұрын

Vinegar is amazing on rust.

@ManiiZilla

3 жыл бұрын

@@JesusMedrano12 never knew of this but ty I may try it on some rusty tools I got

A hand held Sandblaster from Harbor Freight is only $40 and it would have only taken you 20-30 minutes plus it gives you a better surface to start on.

Damnnn u got sum real talent there 👏👏

Great work !

Slappy work

Awesome video

classic Mopar’s of the 60’s can benefit greatly with the use of 70’s , cop car rims , while retaining a stock appearance

I’m going to give it a shot something to do and get a little extra 💰great idea!

those little spots of rust will bubble up under the paint before long. Mostly just a cosmetic thing but still, if you're gonna sell them to someone you have to be up front about the fact they are restored and not new condition

Great work I'm doing the same tire refurbished products

Thank you for the film. I am replacing tires and saw that rims were rusty (not that much like in this film, but rusty, it was like a layer of rust, you wipe it out and it comes back again). I removed that rust w/Rust Remover Navy. It came out rather nice and clean. I was looking for the film on painting. I'm glad I came across this film, very informative, thank you. I have some paint for grills (up to 2000F), I think I can use it. Is it O'K to use that type of paint, or it should be automotive paint strictly? Thank you for you wonderful film again. Very thorough work.

And fuck up your flush cut pliers 😂

pls do more wheel flipping videos! thanks man

@ManiiZilla

5 жыл бұрын

noah smith I appreciate the feedback ! I got some plans for the near future ;)

@noahsmith7905

5 жыл бұрын

ManiZilla awesome! gained me as new subscriber!

I usually sand and paint the area where the tire bead sits since rust in this area can cause air leaking.

@ManiiZilla

3 жыл бұрын

That’s a very good tip thanks for the feedback 🙏🏼

@olenaerhardt7725

Жыл бұрын

Thank you so much for your comment. I'm about to start painting one wheel, and thought it is better not to paint in the bead area, but here came across your statement. Thank you again. Do you happen know if I can use paint for grills (up to 2000F), or it is better to purchase paint for wheels?

@wadeyorke8144

Жыл бұрын

@olenaerhardt7725 I used Tremclad Rust paint (the paint must be made for application on metal) and applied it with a brush. You can also use spray paint, but that ends up costing more, but it is faster to apply and faster to dry.

@olenaerhardt7725

Жыл бұрын

@@wadeyorke8144 Thank you for the replay. And it is very good to know about hand applied paint. I've never used it on cars, but I painted everything inside of the house, I know how to work w/a brush. And I always thought that it would be good to apply some patches on rust spots or smth on a car w/brush sometimes. I'll keep in mind the reference for that paint. CrisFix recommends certain paint for auto, but probably I'll go w/what I have, still it will be better than before. Thank you kindly again.

Awesome job

Good job!

Impressive if you have the tools at home. My sister's benz battery died and I was wondering if you think I could save money by replacing it at home myself (and how), I imagine this could be difficult.

@ManiiZilla

5 жыл бұрын

Shawn Nagra you can definitely save money by changing the battery at home just do your research with your new battery get a nice one and also don’t forget you’ll have to reset the clock on the dashboard

U should try 2 in 1 primer with glossy black spray bomb

Awesome. Thanks so much

Did you divide the 400 by the hours you put in?

@angelseliteautodetailing

2 жыл бұрын

It's per Rim

@MACPAIN

2 жыл бұрын

@@angelseliteautodetailing per rim what?

Question: shouldn't you use a microfiber cloth on the rims after everything to get any residue or rust powder that the air didnt get off

@ManiiZilla

4 жыл бұрын

Seamus Bean normally id use a microfibre cloth on an aluminum rim but there were tiny rough spots on these steel rims that the microfiber would’ve stuck to so instead I just pressure washed the rims to get any loose dirt/rust off Good question though I appreciate the feed back! 🙏🏼

@bobbybeattie4738

3 жыл бұрын

@@ManiiZillafacts that would be a good way to waste a good micro fiber towel my auto correct changed it to micro ginger towel I should have kept it. But yea a good shop towel is perfect for that.

What about the mounting and balancing? You did not include that?

@ManiiZilla

3 жыл бұрын

9:15 I mounted tires and balanced them

They look great....

I use soft whire wheel for curvy spots

Manny I'm a 65 year old woman and I want to know which rust spray to use so I can spray on the rust on my car I need to fix that shit

That spray paint you're using rustoleum can i use that to spray on rusted parts underneath my car cause I'm tired of seeing that rust so please school me

@ManiiZilla

4 жыл бұрын

Daniel Powell Hey my dude you could do that if it’s just for the appearance but the rust is still gonna grow underneath the paint, if you really wanna do it properly you gotta remove all rust with a grinder or sandpaper and then paint over it but if you don’t really care too much and just wanna paint over it you could but it’s not gonna look that smooth painting over rust

@danielpowell6260

4 жыл бұрын

@@ManiiZilla well that's going to be a lot of sanding lol but i will see what i can do lol and thanks for the help

👍👍👍

Cost of materials?

@ManiiZilla

4 жыл бұрын

Professor Eggplant I spent $30 in total

I've a 1996 mercury Grand marquis gs and it's 24 years old and i love the car but i want anpther grand marquis like a 2003 or 2004 it doesn't matter but i want that car but i will get it lol. I put my car on the lift and i see a lot of rust so can i spray that spray paint and it will make it look better instead of seeing that rust please help me select the right one

👍👍

An easier and better way is to head to Home Depot. pick up a jug of metal/floor prep. Add it and a couple of gallons of water together in a plastic garbage can. Gently drop the rim into the solution and call it a day. Next day take it out and rinse the rust free rim off. These rims can be de-rusting themselves while you go to work and make real money ,lol. The solution can be used over and over. Realistically, I get the free rims, but tires ? Get out. Not a real world free item.

@TheREALOC1972

2 жыл бұрын

Or go to Harbor Freight and get one of their hand held sand blasters like I did, it cost me $30 5 years and it only takes 20-30 minutes per rim, I can literally do 2 rims throw on the first coat of paint and then do the other 2 while the first coat is drying and then paint them and let them dry and do the 2nd coat well within the 2 hour flash time.

Everything in your garage has black paint on it.

Your profit margin is not realistic.

@ManiiZilla

4 жыл бұрын

LS Killer it is realistic considering I got the rims and tires for free, it’s not realistic for everyone else

That looks like the 2007-2014 Mazda2 steel rims

@draper5058

3 жыл бұрын

Just relax