How to treat air moisture from the compressor - Tips and Tricks with Jim Colt
In this episode, Jim Colt, an industry veteran from Hypertherm, talks about how to treat air moisture from the compressor so it doesn't affects cut quality. Visit www.maverickcnc.com/ for more information on all of our plasma cutting tables.
Be sure to subscribe to our channel and click the bell icon to get notified when new “Tips and Tricks from Jim Colt” videos are released.
For more information on all of our plasma cutting tables visit our website or social channels
maverickcnc.com
MaverickCNC/
MaverickCNC
maverickcncplasma
Пікірлер: 5
I hard piped mine to the table and have a 4" gauge at the machine I can see from most of the shop. Having that gauge has saved me from having the machine stop cutting in the middle of a job. But now with 2 upright 175psi compressors had no close calls
Would using a second or even a third storage tank in series dry any air if it let the air cool before going on to the next tank?
Rusty water is common for my tank, even though it's still new.
Wouldn't an intercooler be efficient and less trouble than these spin down filters. Any pressure loss would still be ahead of the pressure switch.
💪👍💯