How To Set Up Your Rockville PS40 4 Channel ATV/UTV/Motorcycle Bluetooth Amplifier IP65 Micro Amp

Ғылым және технология

Rockville:
www.rockvilleaudio.com/ps40/
Amazon:
www.amazon.com/dp/B0CQTD2VJF?...
eBay:
AudioSavings:
Walmart:
Description:
The Rockville PS40 is a 4 channel amplifier that is perfect for any powersport application like UTV, ATV, motorcycle, etc. It will deliver 85 x 4 watts RMS @ 2 ohms. We dyno-test the amp to make sure you get the power we promise
This amp is IP65 which means even if you submerged it in water for a few seconds it will still function fine. This means you do not need to worry about your amp breaking when you spray down your vehicle. The amp also has waterproof silicone covers over the control panel and inputs to give additional protection.
The built-in Bluetooth is great because you do not even need a head unit or controller. You can just install this amp and wire it to your speakers and then Bluetooth your phone to the amp.
This amp is super compact making it easy to install into tight spaces.
If you want the most waterproof and high performing powersport amplifier on the market then the PS40 is a great option for you.
Features:
Rockville PS40 4 Channel ATV/UTV Bluetooth Amplifier IP65 Waterproof Micro Amp
Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top premium brands)
2 Ohms: 340 Watts (4 x 85 Watts)
4 Ohms: 200 Watts (4 x 50 Watts)
4 Ohm Bridged: 340w (2 x 170 Watts)
Peak: (Use these ratings when comparing with the top budget brands such as Boss,
Power Acoustik, etc)
Peak 2 Ohms: 1350 Watts
Built-in Wireless Bluetooth with Auto Pairing (You can run this amp without any receiver)
IP65 waterproof rating
Waterproof silicone covers on all inputs and control panel
Conformal coated circuit board
Anti-rust materials
Micro Size amplifier can easily fit in tight spaces making it perfect for Motorcycles, UTV, ATV, etc
Digital Class D Audio Topology
Distortion (THD): ≤0.5%
Independent Crossover Controls for CH1-2 and CH3-4
Full Range/Low Pass/High Pass Crossover
RCA Low level inputs and High Level Inputs (with Auto ON)
Selectable LPF/FULL/HPF with Variable Crossover Frequency: 50Hz-250Hz
Selectable 0/3/6dB Bass Equalizer
Waterproof RCA Input
Frequency Response: 20Hz-20KHz
Signal to Noise Ratio: (1 Watt into 4 Ohms) ≥75dB
Input Sensitivity: 0.5V-15V
Stereo Separation: ≥45dB
Fuse Rating: 30A
High-Speed MOSFET Power supply
Status Mode LED Indicator
Dimensions (Inches): 7.56" L x 3.66" W x 2.07" H

Пікірлер: 8

  • @christianrobles7561
    @christianrobles75613 ай бұрын

    Y'all guys i just ordered this amplifier yestersay and waiting for it. I've looking for the owner manual to see what the wires gauge is, power, acc, speakers to order and install directly, but have to wait till get the amp and check that

  • @jeffo.3811

    @jeffo.3811

    2 ай бұрын

    How was it? I want to hook up some 6x9s on my Harley

  • @christianrobles7561

    @christianrobles7561

    2 ай бұрын

    @@jeffo.3811 Honestly I haven't installed, I will install as soon as I get my very last wiring. I'm still waiting just because ordered everything to do my own installation lol. But I can tell you what I like and what not, as soon as install I will update my review

  • @christianrobles7561

    @christianrobles7561

    2 ай бұрын

    @@jeffo.3811 But what I like about hardware is this amplifier feels good, does not feel like chinese crap u know, the size is really compact but not micro, is little bit heavy for it's size so I like that aspect to, the spec claims 60 rms x 4ohms but the dyno sheet claims at least and no less than 45.5 rms per channel at 4 ohms, to be honest haven't checked the spec in bridged. Things I don't like are the power wires are too small, 14awg for positive and ground and the instructions says they have to be connected at minimum of 10awg wire or if get hot 8awg, and speaker wires are good at 18awg for that power.

  • @jeffo.3811

    @jeffo.3811

    2 ай бұрын

    Thank you

  • @christianrobles7561

    @christianrobles7561

    2 ай бұрын

    ​@@jeffo.3811 Finally hooked up this amp paired with 4 rockfords m-0 6.5. It is pretty easy to set up the gain and tune the sound. I have a boss marine stereo and can't match the gain in my oscilloscope for some reason. All I can do with my head unit is turn on the amp but can't up/down the volume or change the track. About sound quality, it's not very loud but pass, I don't hear any distortion wich is cool. If You want some easy and fast and install I would go for this one, if you want something better that can control with a stereo I would go for an amp that is not Bluetooth like Mb quart, hifonics or rockford.

Келесі