Absolutely brilliant 👏 greetings from Scotland a fellow South African, I knew it could be done by a south african 😅

welcome to Africa.

@Fadil1954

Жыл бұрын

I can relate to that 😂😂😂

This one it won't started, this timing is total out

Do you have timing marks on the cam sprocket

Can i use old camshaft bolts?

Hello, how are you lining up the camshaft sprockets? Is there marks to go by?

Your video went quiet after around 10 minutes. What was going ON and what engine type is thissssss???

engine started?

The tool lines the cams....no way this engine runs...it may run but c.e.l immediately for timing and vanos codes...those cams have 0 marks..the tool is the lock and the timing align for the vanos and cam sensors

@josebaca9694

10 ай бұрын

😂😂This a joke right ✅️

You missing a torx bolt above the one there on the chain assembly.🤕

Can i email you with questions? Do you have Facebook? My cam gear spin but cam not moving. Bolt the go thru the gear to the cam snapped off. Need to know how to reset the cam so it's back in time

@based7144

3 жыл бұрын

Hi. When the gear turns and cam doesn't it's means that you gear is faulty. The gear has a spring inside and it turns to fail. Your car will lose timing even when turning engine by hand. I had the same issue with my exhaust camshaft gear. Replaced it and the cam now turned with the camshaft. Replce the Vanos gear

Hello bro one help me

Hey man how to replace chain with guides and tensioner,thers no video in whole youtube :(

@fataartaliep9463

3 жыл бұрын

Try a channel called '50skid' he does videos on e46 330i

@SanDoval201970

3 жыл бұрын

kzread.info/dash/bejne/lISNz6ujiMi3dag.html

@SanDoval201970

3 жыл бұрын

this will give you a clear a idea go to 21:45

Can this also be done on an N52 engine?

@areebhaque991

4 жыл бұрын

Yes

@SurginersYT

10 ай бұрын

This is an N52

I’m ctfu. My man using a stick to locate TDC & turning the crank with the chain laying without tension 🤦‍♂️🤦‍♂️

@suprafly89

2 жыл бұрын

There’s always more than one way to get the job done ✅

@livingthelife8443

Жыл бұрын

@@suprafly89 hell yeah i was thinking about doing mine this way i have a n54

@kellycherefant9909

Жыл бұрын

Currently doing mines now I can’t wait for the tool to be ordered

buy the tool save yourself a headache!! you can cowboy it like him!! might end up with a $4000 bill after you bend your valves!!! tool is not even expensive!!! think of the tool as insurance!!! that will cover your work had labor and effort!!! dont do this not even worth it. I just did a N20 the 4 cylinder turbo version!! I promise you, you will need tool so you can keep everything lined up!!