This video is intended for loader crane operators and provides step-by-step instructions on how to retract the tiltable stabiliser legs.
DANGER:
- Do not stand in the stabiliser legs, tilting area. Make sure that you can see them clearly during their operation.
- Do not put your foot on the support plate. Risk of crushing injuries. Be prepared to reduce the speed of the operation to prevent accidents.
- Always keep hands away from moving parts during operation.
- Always ensure that the stabiliser legs and the stabiliser extensions are in transport position and securely locked before moving the vehicle.
The procedure of operating the stabiliser legs differs depending on the type of stabiliser leg.
Repeat the instructions for the stabiliser extension and leg on the other side of the vehicle.
For manually controlled crane: Activate stabiliser system operation on the user panel by pressing the stabiliser legs button .
For remote controlled crane:
- Manually controlled stabiliser system: Press button on the user panel to deactivate the controller. Activate stabiliser system operation on the user panel by pressing the stabiliser legs button .
- Remote controlled stabiliser system: Select on the controller the defined menu for the stabiliser system operation.
Steps for retracting tiltable stabiliser legs:
1. If there is an extra support plate for the leg delivered, retract the stabiliser leg a little, if not, go to step 3.
2. Remove the extra support plate.
3. Pull out the locking pin and turn the lever 180 degrees.
4. Operate the stabiliser leg lever. The stabiliser leg will now rotate automatically to a vertical position.
5. Turn the lever 180 degrees and check that the locking pin is in and the lever cannot rotate.
6. Fully retract the stabiliser leg.
7. Retract the stabiliser extension completely.