The hall sensor connector pinout on my hoverboard controller is in the order as the one on the ZS board. If the original hall connector is intact then just connect to the ZS board in the same order. In my case the blue from the motor connected to the yellow and the yellow to the white.

The e/s/c/ needs to be bigger than 80 amps but an 80 amp will work well.

I had the same issue until i rewired it several times. If it runs really fast and makes noice and there is no slow torque the wires might be not right.

ah, you have the same problem I was going to ask about...@3:50, terrible low speed performance in terms of that grinding sound and I would guess also much lower torque relative to the hoverboard controller. I guess maybe these ZS-X11H boards simply can't do smooth low RPM's? The original hoverboard controller obviously does as when you stand on it and lean forwards it can go very slowly and very smoothly forwards. Too bad if this is the case as these ZS boards are way easier to use.

Reverse is broken so almost half of the functionality is bad, it locks up so it's even worse than if they didn't provide the reverse. I hope it can be fixed by mixing around the hall sensor wires. (btw hacking hoverboard motherboards with custom firmwares gives you dual esc without such issues...) Any update?

Hej jag har en liknande setup men min hoverboard motor har jättelite vridmoment när jag använde denna hastighetskontroll. Motor hade betydligt mer vrid moment med kretskortet från hoverboarden

@swishpan

10 ай бұрын

Kretskortet er absolutt best, mer stillegående og mer effektiv. Hvis du bare klarer å kontrollere det.

@swishpan

4 ай бұрын

Prøv å reversere retning og se om der hjelper!

@botak333

Ай бұрын

​@@swishpanwhat main IC they used? Stm32m?

what are your plans for the controllers and the hoverboard motors? I'm working on a setup similar to yours.

@swishpan

Жыл бұрын

Hacking the original driver board is far better in terms of smooth control. I was unlucky about the version of my board and couldnt get a proper firmware for that exact version. But some people are happy with the replacement controller as well.

Is it possible to do 36 volts?

@swishpan

20 күн бұрын

@@mickmeuwissen8717 The board supports up to 60v so just make sure the motor doesn’t get too hot

Using same ZS-X11H. kzread.infovwXGz9Ci9wY Not bad. But! - no direction detect. Only one phase encoder tick; - low encoder resolution, cause same reason - only one hall sensor in output "speed pulse"; - two modules are dead on the same wheel (maybe wheel is broken) at big torque reverse.

@swishpan

4 ай бұрын

So you think the problem with these is that they only use one encoder input?

These boards are really crap.. 6 of them went bad

@swishpan

4 ай бұрын

Sorry to hear, did this happen during normal use, or during stalls etc?

Your driver is broken.