This is a neat idea my friend 🙂

@HandmadeCreativeChannel

Жыл бұрын

🍀👌☺️ Thanks brother

Intelligent..👌👍

So helpful. Mersi ...

Thank you so much to you

I didn't know that, it was very easy. Thanks for sharing with us my Friend🙌🙂🤝

@HandmadeCreativeChannel

Жыл бұрын

Thanks brother👌☺️🙏🍀

Ничего не понятно😅но интересно, досмотрю до конца😂

Watched your video and read comments. Tried to follow your video except for relocating the filler hole. Everything seems to look good. Pressure test showed new tube had a slight vacuum after operating the pump. However, after reassembling, I can’t get any lift on the jack shaft by operating the pump. I’ve manually lifted the jack base to extend the shaft. But still get no shaft response to operating the pump. I’m guessing the problem is with bleeding the air. But I’m at a loss and Ang help would bee appreciated.

Kíc 12tấn bao nhiêu k anh

👍👍👍

Clear and understandable process.... BUT why did you refill with that grotty dirty oil?

@joseanselmogutierrezmendez7427

3 ай бұрын

Saludos, qué tipo de aceite usa?

@N269

3 ай бұрын

@@joseanselmogutierrezmendez7427 I use a light 5W hydraulic oil, made specifically for this. You can probably use Dexron III automatic transmission fluid as well.

@joseanselmogutierrezmendez7427

3 ай бұрын

@@N269 Muchas gracias, muy bien desde Venezuela!

Watching

👍👍💪

I wouldn't change the position of the filler hole, it makes bleeding easier, but it's not necessary.

Just only work upsidown now 🤣👊

Upside down Jack,

Like a bull in a china shoppe - but always great ideas.

@flojotube9323

Жыл бұрын

Why not create a boot to stabilize the new bottom?

N ai arătat cum ai pierdut bilele!

Does it still work the regular way up?

@TheMightyKingzuru

6 ай бұрын

No. It doesn't.

Для чего это не понял

half of the video is how to clean the oil tracks

Why would you need an upside down jack?

@ugurcantekin6585

23 күн бұрын

I will made own my manuel press table.