How to Replace the Seat Foam in a Dodge Ram [How-T0]
Visit Adventure Rig here: goo.gl/OzQc0M
Watch this video if you are looking to replace the seat foam in your Dodge Ram. This video was demonstrated on a 2007 Dodge Ram 3500. Leave any questions below!
Links:
Antares HD Long: goo.gl/JzVGTO
More Reviews: goo.gl/5cuWol
Be sure to subscribe for more great videos and check us out on our social channels!
facebook: / adventurerig
twitter: / adventurerig
instagram: / adventurerig
Пікірлер: 75
Thanks so much for this video. My husband and I successfully replaced the worn, uncomfortable cushions in his 2005 Ram 3500 diesel without removing the seats!!
Thanks for the video. There is one suggestion I would make. The springs and wire mesh is usually much more worn and stretched. What I did with my 07 2500 was to remove the 4 springs and wire, turned over the wire and reversed the order of the springs putting the less used to the outside and the worn to the inside making it as stiff as new. Expecting to get another 100k + miles out of this seat and new cushion, John
Thanks so much! Watched once and it was a piece of cake! Took more time to vacuum up the old rotten foam than anything.
Thank You For making this video, I am about to replace my seat foam as well and your video sure helped me out a lot.
thank you. very helpful video. going to same me some money for sure
Nicely done. As an installer I'd say using your step rails 100% eliminates foam breakdown. Sliding off and on is worse than the little sharp edge on the frame. I liked the video still
Thanks, you made an intimidating job look easy!
Great video, my exact problem, I'm going to order the driver's foam and do it myself, and try moving the springs as someone else mentioned.
great vid thanx definately want to subscribe
Great video! Just replaced mine, thanks for the info!
Thanks, good video. I’ll be amazed if I can come anywhere close to doing it so easily.
Thanks
Great video, do you know if its about the same process on a 2020 1500? Ive lookedd everywhere and cant fimd anything. Thanks.
How did you get the inside tabs to connect to the frame? All the power motors are in the way and I cannot raise the seat either.
This is great! My 2005 seat needs this bad! How come no one is talking about replacing the the seat back cushion? Mine is worn more than the bottom seat cushion is! (You can see the metal frame starting to wear through the material!)
Does it make any difference if the seat is a heated seat? Or not really since you are not touching wires
Thanks, very helpful! Need to replace mine not only because of the wear but the stank butt 16 cans of shark poo that has built up over 12 years!
Where did you find the cushion for $9 I've been on ebay & can't find a cushion for less than $150
Where did you purchase the sticky felt. I can see the rail on my 2006. I need a whole new cover.
Where can i purchas the seat covrer