How to replace the Fuel Door Actuator without any Holes or Puncturing | C7 Chassis / Audi A6 and A7

Автокөліктер мен көлік құралдары

How to replace the Fuel Door Actuator for C7 Chassis / Audi A6 and A7. volkswagen.
Amazon Tools Link: www.amazon.com/your-orders/po...
Part Numbers
The exact part number ( Came directly from the car ): 4lo 862 153 D
The one I used to replace the Fuel Door Actuator bought directly from Audi of Rocksville: 8vo 862 153 A

Пікірлер: 35

  • @will13k7
    @will13k711 ай бұрын

    For anyone else that attempts this, all the videos I saw damaged the Fuel Pocket, either the edges got warped from prying or holes were drilled, so I thought the Fuel Pocket was just sacrificial and ordered that along with the Lock Actuator, but I tried something a little different to see if I could get the Fuel Pocket out without damage and it worked! The Lock Actuator was the broken part for me, so I just used pliers to pull on it and that pulls out the left side of the Fuel Pocket with enough space at the edge to slip in a pry tool to keep it pulled out, then using my hand/fingers along the top edge, I just kept pulling out the Fuel Pocket left to right, a little at a time, until it was free. None of the clips broke. This was done on a 2015 s3, and your milage may vary if you are too rough with it, but it does need strong enough yanks to get it free, just nothing crazy.

  • @donovoncooley6114

    @donovoncooley6114

    11 ай бұрын

    thank you for this

  • @nlz242

    @nlz242

    10 ай бұрын

    +1. I pulled on the actuator itself, enough to get a plastic pry tool in, then pryed enough to get my fingers in and i was able to pull it right off. No broken clips, no warped edges. Reinstalled and looked brand new. Word of warning tho, if you buy a cheaper after-market part (i did) the plastic tabs that hold the fuel door are much flimsyer (actually broke one) than the OEM part and the "click" isn't as positive/satisfying as the OEM part... i guess you get what you pay for. The part is good enough, just not as good.

  • @nikolap2001

    @nikolap2001

    8 ай бұрын

    @@nlz242 When you returned fuel pocket did you put any seal around it or left it like that. Thank you!

  • @nlz242

    @nlz242

    8 ай бұрын

    @@nikolap2001 No seal, it didn't have any before and i managed to remove it without damaging it so it sits as flush as it did before.

  • @nikolap2001

    @nikolap2001

    8 ай бұрын

    @@nlz242 Ok, thanks

  • @darkdantepl
    @darkdantepl6 сағат бұрын

    Hey man, thanks for that tutorial. I've just got it replaced today on A6 C7.5. Took me maybe 15 minutes and I'd score difficulty to 2/10. The actuator cost was £13 and trim tools £3.99 out of Amazon.

  • @harrisonrawlinson5650
    @harrisonrawlinson56506 ай бұрын

    Awesome video, it’s basically the same on the A1 except the trim is circular rather than a rectangle. Thankyou very much

  • @patrick8252
    @patrick82522 ай бұрын

    Thank you man. Saves me 300 bucks at the garage.

  • @jumpinjon
    @jumpinjon Жыл бұрын

    Thank you, I found the Trim Tools worked well for getting started popping out the main body, this was on a 2010 A4 B8 Avant

  • @TrendingDaily1
    @TrendingDaily1 Жыл бұрын

    Lot of help thank you for going through it step by step aimt many vids of this on yourube

  • @HughesYerDaddy
    @HughesYerDaddy5 ай бұрын

    Great job have the same thing going on our audi A6. I’m going to do the same thing audi. Little did I know that the orange cable for the emergency release was actually broke when I went to try it. So I have to feed that through. I took out all the interior on the right side of the trunk to get at it. This way is much easier. Thanks man again greatly appreciate it.

  • @alolaiwi89
    @alolaiwi89 Жыл бұрын

    Very useful, well done 👍

  • @cisco2x699
    @cisco2x699 Жыл бұрын

    R/o bro, well shown nd said 🙌🏽😄 finna do this right now as every usual guy/men we learn from ppl like you much love bro 🖤

  • @steved6473
    @steved64732 ай бұрын

    Thanks for the video. I was going to order an actuator but sprayed some WD40 on the stem that fits into flap. Overnight it seems to have done the trick. The fuel flap now consistently opens with the remote. If I become stuck again I’ll replace using this method but probably pulling from the stem to avoid damage to the seals.

  • @angelahowze6423
    @angelahowze6423 Жыл бұрын

    Awesome video, where did you get the tool kit with all the blue pieces and the hex screw driver ?

  • @DriftyJayy
    @DriftyJayy7 ай бұрын

    Thanks, mine got stuck and only way to get it open is to use my debit card

  • @IrishSpud
    @IrishSpud Жыл бұрын

    👌👌👌👌

  • @jasonjay7650
    @jasonjay76506 ай бұрын

    Mine is still locked shut and pull cord dose nothing. Any idea how to get flap open?

  • @Andys5v8
    @Andys5v86 ай бұрын

    The corporate 😂

  • @ruisalvador192
    @ruisalvador1929 ай бұрын

    Why didn't you just pull the red string inside the trunk?, this would open the lid, then just take the fuel cap off, and stick your fingers inside the rubber and pull firmly on the left side (side of the micro switch). If you can't pull, on both sides, from above and below, you have places to insert a small screwdriver that forces internal tongues downward. This will release the part that must be undocked by the left side where the micro switch is.

  • @pious3558
    @pious35584 ай бұрын

    OMG 🥵 USE YOUR BRAIN IF YOU HAVE !!!!!!!!!

  • @mybnz190
    @mybnz190 Жыл бұрын

    The corporate?

  • @some__jerk

    @some__jerk

    Жыл бұрын

    If you aren't joking and really didn't understand him, he said culprit.

  • @CharlieSmith-ly9py
    @CharlieSmith-ly9py6 ай бұрын

    Electronics made in Italy, therein lies the problem 😂

  • @eddyviera5737
    @eddyviera57379 ай бұрын

    Honestly I'd just leave it unlocked, of someone wants to steal ur gas they can pry it open with a screw driver in 10 seconds

  • @tangodrizzle
    @tangodrizzle Жыл бұрын

    its stupid but it is better to just go ahead and poke holes to get the tabs that way you dont complete destroy the seal around the edge like you did. And if you keep the holes small enough you can use a torch to kind of seal the holes halfway back so it doesnt look to terrible. Either way this is a dumb design by Audi and you cant even get to the clips from the back by taking the wheelhouse liner out. They want you to break it and replace it so they can keep raking in the big bucks

  • @CheckDisOutpeeps
    @CheckDisOutpeeps7 ай бұрын

    Dont do this people.

  • @Assimilator702

    @Assimilator702

    5 ай бұрын

    Any suggestions?

  • @CheckDisOutpeeps

    @CheckDisOutpeeps

    5 ай бұрын

    @@Assimilator702 Take it to Audi.

  • @Assimilator702

    @Assimilator702

    5 ай бұрын

    @CheckDisOutpeeps For something that easy? Yeah right.

  • @CheckDisOutpeeps

    @CheckDisOutpeeps

    5 ай бұрын

    @@Assimilator702 It’s cheap. Better than damaging your car.

  • @luiszubillaga1463

    @luiszubillaga1463

    4 ай бұрын

    Audi would charge $600 to do this..

Келесі