This #diy video shows how to #replace the Drive Unit on a CVT RS800 #transmission of a riding lawn mower or lawn tractor.
The Drive Unit spins the Driven Pulley to move the riding mower.
Replace the Driver Unit when it locks up and won't spin.
Order the part www.searspartsdirect.com/prod...
Get 10% OFF parts using promo code KZread.
Transcript:
The repair we're looking at is the loss of drive -- and in this case, what we have is a damaged drive unit. If you notice, the drive unit will not rotate.
So, what we've done -- we've ordered a new drive unit. When you order the new drive unit, in the kit will come instructions, 4 new screws, the new belt and a complete unit. Always check to make sure that the unit does spin freely. And, we're going to change this unit out with the correct unit.
We're going to start with a T-25 Torx and remove the screws. Once the 4 screws have been removed, the unit will then move and then release from the cradle. Release the arms. Remove the unit and the belt. When reinstalling, make sure that the speed screw is on the outside. Make sure that the arms snap into the cradle. When reassembling the screws, we're going to use blue Loctite -- just a dab. We're going to torque the screws to 2.5 ft-lbs. You want to make sure that the wheel spins freely.
If you need to have a Sears Technician install the new Drive Unit on your RS800 transmission, schedule service at www.searshomeservices.com/rep...