How to Replace Rear Shock 2002-2005 Ford Explorer
Buy Now!
New Shock & Spring Assembly from 1AAuto.com 1aau.to/ia/1ASH...
New Shock & Spring Assembly Set from 1AAuto.com 1aau.to/ib/1ASS...
This video shows you how to install rear shocks on your 2002-2005 Ford Explorer. A shock and spring complete assembly simplifies installation. You don't need to separate the spring from the shock absorber.
This repair was done on a 2002 Ford Explorer XLT 4.0L Sport Utility 4-Door and the process should be similar on the following vehicles:
2002 Ford Explorer
2003 Ford Explorer
2004 Ford Explorer
2005 Ford Explorer
Tools you will need:
• Flat Blade Screwdriver 1aau.to/op4/1AX...
• Pry Bar 1aau.to/oen/1AX...
• 13mm Wrench 1aau.to/oeg/1AX...
• 14mm Wrench 1aau.to/oeg/1AX...
• 18mm Socket
• 21mm Socket
• Torque Wrench 1aau.to/ojy/1AX...
• Rust Penetrant
• Hammer
• Jack Stands 1aau.to/oep/1AX...
Subscribe: / @trq
Check out our playlist:
Ford Explorer 2002-2005 3rd Generation: • Ford Explorer 2002-200...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
Пікірлер: 15
√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money
I enjoy your videos the are very informative. It wasn't as easy as that, I couldn't get the strut out the way you did it I had to remove the outer dolt from the lower control arm and push it down far enough to remove the strut.
I can't get the toe-link to just pop out like he does at 2:30. Help !
And that's how we do that...!
What is the length of the proper rear shock and strut assembly for this and what is the proper length for the rear stabilizer bar link for this 2004 ford explorer
What is the torque spec for the knuckle to the lower control arm?
What is the torque spec for the bolt that is the knuckle and lower control arm
Should’ve tried a 6point wrench instead of a 12 point
Can i put anti-seize on the thread for any bolt i remove ? Tha k you 👌🙏
@LA_Commander
Жыл бұрын
NO!!!! Do not do that on suspension bolts.
Hey Lenny, I thought you worked for 1AAuto?
You put a new end link on for the video instead of showing how hard it is to remove
What did you use to cut
@BRadWilson3
Жыл бұрын
probably a torch
@williamvaughn9870
Жыл бұрын
@@BRadWilson3 driver side is close to gas tank filler hose, be careful!!