Thank you! I was able to do a repair myself, it was not easy, The gear attached to the motor was half gone, but I managed to make it working by raising the other gear wheel with an additional washer! It works fine now, not sure for how long though 🙂

The brush on my N8 Pro+ quit spinning, watched this video, bought the part online for $30 or so bucks at amazon, followed the video and the robot fired right up after assembly. On my Brush Motor, the pinion gear on the motor had stripped due to hair getting in and displacing the lubricant. Thanks Guys, saved me some money in these expensive times!

Dear Ecovacs support. I had a problem with our Deebot N8 Pro+ the main brunch was very noisy. I have decided to buy a new robot an I did it. But After watching your videos I decided to try to fix our old one. I could not find the main motor in USA but I bought one from china. After 20 days the new motor arrived and I assembled the robot today. It was completely disassembled and now IS WORKING PERFECT!! I am writing to thank you for for great video teaching us how to disassemble and assemble the Deebot. Thank you so much! I hope you can get some compensation from You Tube. It was a awesome experience for me. Thanks again for your generosity.

This video was of so much help in replacing the main brush motor. Without this I would never have even attempted it. Thank you very much. Extremely detailed and also you mentioned all the little things in between which were of great help.

Excellent video, thanks. Just working through doing this on my N8 Pro. Have to say, it's a fucking stupid design that there's no access panel for that motor.

How about the H77R?

Thanks for this video, it saved me so much money! When I was disassembling a small rubber piece jumped out and I can't figure out where it needs to go 😅 is there anyway I can send you a picture of it? you can probably tell what it is

Dear Sir, I have Deebot 950, the right side bruch is making noise when the robot is at the corner, otherwise it works best and there is no noise. I opened the robot, thanks to this video. When the gears are checked, they don't seem to have any issue. When I cleaned and regreased the gears, I can see the gears are slipping. I need a help to get the gears, is it possible?

Thank you very much, the video helped me to replace the motor, but i have an problem now: when i start the deebot it is cleaning backward and stops with the problem „bumper blocked“. What did i wrong?

I tried to reconnect the "carpet sensor" in my 950, but i can't find where to plug it into. I dont know if i did anything wrong with taking it apart but can find it

This video was so helpful! I would never have been able to repair my T8+ without it!

Thank you very much for this video. I just completed a replacement following your instructions and I do not think that I could have done it without your guidance. Well done boys! 🎉

Thankyou, have never completed anything like this before and your teaching style is so easy and effective

My main brush was feeling bound tightly at random intervals of rotation. His very detailed instructions allowed me to get the motor out and remove my animals hair/grease sludge from the gear box, re-lube and put our Deebot N8 Pro Plus back in action. Very minor differences in some wires and screw locations, but I would have never pulled the motherboard to get to the motor without his instructions. Thank you for this!!

Thankyou!! We ordered the motor off eBay and fixed it our selves really appreciate your help!!

Thank you for showing how to replace motor. My Deebot is now up and running like it should and you saved us some major monies.

Thank you was finnecky but your video helped me replace the main brush motor

i am replacing the brush motor; i disassembled the deebot, and i am so grateful for this video to help me re-assemble it back 🙂

Thank you for the video guide! You covered it well.

Brilliantly explained 👌 👏