How to Replace Front Driver Side CV Axle Assembly 2009-2014 Nissan Maxima
Buy Now!
New CV Axle Assembly from 1AAuto.com 1aau.to/ia/1AAC...
This video shows you how to install a new front driver side CV axle in your 2009-2014 Nissan Maxima. A CV axle has flexible joints. Often, these joints wear out, or seize from contaminants due to the protective boot tearing open. A worn joint is prone to breakage, or other hazards. If your vehicle needs a new CV axle, install a quality TRQ axle that is engineered to your vehicle’s specifications.
This process should be similar on the following vehicles:
2009 Nissan Maxima
2010 Nissan Maxima
2011 Nissan Maxima
2012 Nissan Maxima
2013 Nissan Maxima
2014 Nissan Maxima
Tools you will need:
• Pry Bar 1aau.to/oXB/1AX...
• 18mm Wrench
• 18mm Socket 1aau.to/oanK/1A...
• 19mm Socket 1aau.to/oanK/1A...
• 21mm Socket 1aau.to/oanK/1A...
• 32mm Socket 1aau.to/ocZ/1AA...
• Metal Cutters
• Pliers
• 1/2 Inch Impact Gun 1aau.to/ou9/1AX...
• 3/8 Inch Impact Gun
• Ratchet 1aau.to/obIN/1A...
• Torque Wrench 1aau.to/oaMS/1A...
• Copper Anti-Seize
• Cotter Pin
• Gloves 1aau.to/oaop/1A...
• Safety Glasses
• Drain Pan
• Floor Jack 1aau.to/oabY/1A...
• Hammer
• Jack Stands 1aau.to/oYU/1AX...
• Rubber Mallet
• Small Hook
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
Пікірлер: 6
√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money
You are a good mechanic which sometimes mean your a great person?🤔👊👊
Thanks for this video!!!
Thank you....❤❤❤
my cv axle is not fitting flush with the housing, there's like a half inch gap . is this normal?
How about the floating ring that goes on the spline at the end does it have to be lined up?