How to Replace CV Axle Shaft 2002-2005 Ford Explorer
Buy Now!
New CV Axle Shaft from 1AAuto.com 1aau.to/id/1AAC...
This video shows you how to install a CV axle shaft on your 2002-2005 Ford Explorer. A CV axle has flexible joints. Often, these joints wear out, or seize from contaminants due to the protective boot tearing open. A worn joint is prone to breakage, or other hazards. If your vehicle needs a new CV axle, install a quality TRQ axle that is engineered to your vehicle’s specifications.
This process should be similar on the following vehicles:
2002 Ford Explorer
2003 Ford Explorer
2004 Ford Explorer
2005 Ford Explorer
Tools you will need:
• Pocket Screwdriver
• Pry Bar 1aau.to/ob/1AXA...
• 14mm Socket 1aau.to/oa/1AXA...
• 18mm Socket 1aau.to/ob/1AXA...
• 19mm Socket 1aau.to/ob/1AXA...
• 24mm Socket
• 30mm Socket
• Pickle Fork
• Trim Tool Set 1aau.to/oa/1AXX...
• Locking Pliers 1aau.to/oa/1AXA...
• Side Cutters
• 3/8 Inch Air Impact Gun
• Torque Wrench 1aau.to/ob/1AXA...
• Bungee Cord
• Center Punch 1aau.to/ob/1AXA...
• Hammer 1aau.to/ob/1AXA...
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
Пікірлер: 14
√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money
Videos like this make me grateful that I don't live in the rust belt. My '03 190K mile Explorer doesn't have a spec of rust anywhere and all of the bolts come off easily. It's been the same for every car I've owned from MY 1989 - 2017.
Clean video. Ty for showing us in detail. Most videos out there are pretty bad quality on this particular explorer.
Thanks for a great video. How hard was it to move the sway bar up to allow the long bolt to get in? If it was hard, why did you not show that task? How did you do it? Thank you.
Tanks yaALI
Is this the same for a 2005 ford explorer sport trac 4x4?
Don't do the lower ball joint just upper and tie rod end plus breaks and sensor behind rotor it will come out
Gracias...muchas gracias...
top ball joint would not separate from the knuckle?? your thoughts
@brettleist7563
Жыл бұрын
Pickle fork and hammer
@triizzmattiicz
Жыл бұрын
Beat it with a hammer 🔨
19:05 I really hope that was for demonstration purposes. There is no way you torqued that to 184 ft. lb. with that length torque wrench and force used.
A++ you save me $$$$
🌹