Watch this video and save yourself over $300!
👋 Welcome back to "Flix It Yourself" Tip 37! Today, we'll tackle the common issue of moldy rubber seals on washing machine doors. Here's a simple 5-step process to get rid of the mold:
Caution ⚠
This FIY should be done only by adults.
Make sure to use gloves mask and eye protection.
Make sure the bleach, etc. doesn't get onto any clothes.
⿡ Clean the rubber seal with a bleach-based cleaner. Use a good scrubber to reach all corners.
⿢ After cleaning, spray bleach again over the entire seal and sprinkle pool shock. Make sure to cover all corners.
⿣ Let it sit for 30 minutes, then clean off as much of the pool shock as possible with a wet rag.
⿤ Turn on the machine and run a load on the sanitize or cleaning mode.
⿥ Open the door and witness the magic! 🎉
• To prevent the mold from happening again, purchase the magnetic stick that will hold the door open when it's not in use.
• Remember to clean the machine once a month with a cleaning pod to reach those unreachable places.
For the products mentioned in the video:
🔹 Pool Care Shock: amzn.to/43K6VD8
🔹 Amazer Dish Brush with Handle: amzn.to/4ae9xLR
🔹 Clorox Cleaner with Bleach: amzn.to/4cHNVcf
🔹 Magnetic Stick to hold the door open: amzn.to/49iouLA
🔹 Washing Machine Cleaner: amzn.to/3xqmbsq
If you enjoyed our video, please leave us a nice 5-star review! 😊
g.page/r/CVvo19wIleurEBE/review
Have a wonderful week.
Affiliate Disclaimer: The products showcased here are associated with Amazon, and we may earn a commission for qualifying purchases. We want to be transparent with our audience and appreciate your support.
#howto #diy #cleaningtips #molds