No video
How to open Casio Classpad fx-CP400 Calculator
Need to fix or clean your Classpad calculator? All you need is a small screwdriver and some plastic spudgers or levers. #classpad #casiocalculator #teardown #clean #fix
Need to fix or clean your Classpad calculator? All you need is a small screwdriver and some plastic spudgers or levers. #classpad #casiocalculator #teardown #clean #fix
Пікірлер: 9
I dont know if you still have this or anything but do you know if you can upgrade any components like ram or something to make it faster? or is it all locked by casio
@3rddrawfixer57
2 ай бұрын
I doubt it.
Do you also have any solution if the calculator is broken( it doesn’t work because the screen is always dark I already put new batteries in and ist doesn’t helped) thank you
@3rddrawfixer57
Жыл бұрын
Put the batteries in and shine a torch on the screen to see if anything shows on the screen. It could be a backlight issue. Also check for any corrosion or damage to the ribbon cable at the top of the calculator that connects the screen to the board.
my calculator's screen input isnt working in the bottom left corner. I think the issue is that when I tap anywhere, especially in the bottom left, the input is adjacent to it. Thus I cannot even press the bottom left cross to access my calculator. Would you happen to anything about that.
@3rddrawfixer57
Жыл бұрын
Sounds like a broken digitizer. Unfortunately there's no fix for that other than replacement.
I have the following problem: The touch-display reacts when I tap on it, so the backlight first gets darker when I wait for a moment, then when I tap on it it gets bright again. This means it reacts to tapping, but not to WHERE I touch. This means I cant calibrate it, I cant even make it through the settings after putting it on. Do you know, what a possible reason is for this? Thanks in advance!
@3rddrawfixer57
9 ай бұрын
Sounds like you have a damaged digitizer. No fix for it.
@above7846
9 ай бұрын
@@3rddrawfixer57 That is sad. But thank you VERY much for this quick help! Yesterday, although I resented and initialised + calibrated the display touch on the very left (0,5 cm from the rim) didn’t work, so I read what to do and on the Internet it said: Heat it up. So that’s what I did and where I probably broke the digitizer. Thank you!