How to Naked GoPro - Part 2: Flywoo Naked GoPro V2 Assembly
Instructions on assembly of the Flywoo Naked Naked GoPro V2 DIY kit
This is the second and last step of the GoPro Naked mod.
GoPro used: Hero 11. Video applies to GoPro 9/10/11/12.
Any issues with the lipo connection? Or do u get the message of low battery warning?
Install the latest GoPro Labs firmware! This will fix the issue.
community.gopro.com/s/article...
Пікірлер: 13
I use them but the first time I see it inside, good video, thanks for sharing.
Thanks a lot👌🙏🤙
wow thanks!
Thanks for this. It would be great if you can do a how to video for the touchscreen kit how to video too.
@ALVA_FPV
2 ай бұрын
i did indeed bought the touchscreen kit aswell. Tbh mounting the original gopro lcd inside it is near to impossible, bc u have to get it out of the whole plastic surrounding. I tried, i broke it, but it is still working. My advice is to buy a gopro lcd from aliexepress and install that (its about 36€). I you still want me to show the assembly with the broken lcd, i will glad to make this video for you
Great Video - how to install the labs firmware?
@ALVA_FPV
Ай бұрын
best done before disassembly. You just need an SD card and firmware itself. You can find it here: hgopro.github.io/labs/. Just unzip the archive and put the entire UPDATE folder on the sd. Insert SD, power camera on and wait a little. You can find details here: gopro.github.io/labs/install/
Hi, is it necesary to truncate the main logic board in order to fit in to the case sir?
@ALVA_FPV
Ай бұрын
hey, unfortunately YES. For this specific case you will need to cut it. But don't worry, it was just a grounding edge as long as I remember.
Awesome Video! I just assembled my V2 (GoPro 10) but it is not working. When I disassembled my GoPro-i didn't think to keep the microphone. Could this be the issue?
@ALVA_FPV
2 ай бұрын
It definitely runs without the mic! I would check the soldering on the BEC board and if the gopro is getting enough power. Also make sure to preinstall the labs firmware.
@BeeSight
Ай бұрын
@@ALVA_FPV Hey ! Just made my naked Hero 12. I did it exactly like you, but somehow it doesnt record when powered on... I formated the SD, have the last version of goprabs labs. It reminds me when my naked Hero 8 didn't have enough power (need to solder 2 pads)... But here I used the original pin connector, and also the pads just on the right, but nothing works. Did a miss something concerning the power input ? Can you please help ?
@ALVA_FPV
Ай бұрын
@@BeeSight hey, I am not quite sure. I would try to reinstall the firmware and check the wiring. You are welcome to send me a pic of the assembly on my insta: alva_fpv