This is perfect for what i need! Gonna make one next week if i have time.

Gave me a few ideas for a problem that I need to get past. My good live centers don't let me get close to the end of the work but something like this could help, and If I extend the live portion out a bit I could get very creative. Those bearing cannot take a lot of axial load, but adding a small thrust bearing would help a lot.

I learned more in this video ťhen the last 100 I have watch. Great job, thanks

@olivvapor4873

11 ай бұрын

Thanks ; Why 62° , and not 60 ? ... 😶

Would a small lip on the bottom of the spinning shaft help seat it against the bearing and leave a little bit of space between the spinner and the holder as a thrust washer kinda thing Still a pretty cool build...simple and fast and does what it's supposed to...how accurate is it? Does it have much runout?

@metallantik

9 ай бұрын

Thanks ❤️🙏 Its accuracy is good, maybe not very principled, but it gets the job done

Thank you

It looks like you used a beaver to chew that Morris taper

@metallantik

Жыл бұрын

🙏Thanks for the point

If you push anything with that center it will most probably lock out as you did not used any axial bearings. It's out of center and the finish quality is terrible with these diy cutters. You could achieve much better quality.

@metallantik

Жыл бұрын

Of course ، thanks ❤️

@hyspecs7906

7 ай бұрын

😂😂😂

👍

@metallantik

10 ай бұрын

❤️

That was easy

👌👌👌

😍👌

@metallantik

Жыл бұрын

Horiiiiit , che familet mord

@leila7963

Жыл бұрын

😐

👏👏👏👏

👏👏🌹

😍👌🏻

Good job but lilte rough

@metallantik

Жыл бұрын

Tnx a lot 🙏❤️

perfect 👌

measure wobbling 😂

Nice 😍🤍

👏👏🌹