Your next video should be adjusting the sound; radio, amp, and amp at the powered subwoofer. Thx!

Great video! Installing an amplifier for your car audio system is easy when following these steps. Thanks for sharing! #caraudio #bassamp #installationtips

Great tutorial on how to install an amplifier for your car audio system! The step-by-step guide made it easy to follow along and understand what needs to be done. Thanks for sharing! #caraudio #ampinstallation #diyproject

Bruh my speaker smoking

@Kozyboy710

2 ай бұрын

Damn bruh what song you playing?! 🔥🔥

@Nickjustdabs

2 ай бұрын

Speaker chill asf😶‍🌫️

@daaafoo8857

Ай бұрын

Bruhhh

Can I use any hi to low adapter ?

Where did you buy those spacers?

Hey if to put all cables in drive side is problem?

Hey man maybe you help after installing a after market headunit (kenwood) with after market rear and front speakers , no subs no amps, my soeakers sound terrible worst than before, coukdnt even turn up without distortion, so i got a 4 channel amp to power those speakers and my front speakers are so quiet compared to the rear, its bad enoughy i have to turn the head unit volume damm near to 30 just to get some loadness cant harley hear anything at 15, but why is my front speakers so low

@sinkars5617

Ай бұрын

Did you figure it out

When installing the amp I know I ground the amp to the chassis, but do I ground the chassis to the battery? Asking cause the amp says do it this way in the little booklet it comes with.

@kalybmcnamara1923

Ай бұрын

Just ground the amp the Chassis.

Where did you connect the remote and rc wire too

@thatguykai479

4 ай бұрын

Tapped most likely to a fuse down below the drivers side or passenger side maybe IGA1 which is ignition or fuel pump or fuse 18 id check fuse 18 in your manual tho fuse 18 is for my car also I believe there’s a remote wire in the stock headunit you can splice into but that’s a whole lot more work. Make a ring with your remote wire wrap it around one of the silver pieces or rods to your fuse after pulling it out and plug it back in.

Im excited

@BreakersStereo

4 ай бұрын

Me too!! 🤣🤣🤣

Imagine if the cordless drill slipped whilst screwing in the subwoofer 😮. That's what hand tools are for

2 12s n 1200 wat

Im doing an install on an aftermarket radio where do i hookup the remote wire to

@tjbenson6185

3 ай бұрын

Red wire

@makz.1000

21 күн бұрын

@@tjbenson6185you wrong bro😂

3:27

Good day po how much subwoofer amplifier set up

@BreakersStereo

Ай бұрын

$150

Why do you run the RCA cables and signal cables on the opposite side of the power cable???

@BreakersStereo

3 ай бұрын

To reduce feed back.. on subs it’s not that big of a deal vs an amp for mids and highs but it’s good practice

@edp9517

3 ай бұрын

@@BreakersStereo any idea why my subwoofers would be humming extremely loud as soon as I power on the head unit

@noharmjones3310

Ай бұрын

Mine has kickback when I turn mine off

@ConleyrdNate3297

5 күн бұрын

Interference from the power cable

What soeakers did you attach to the adapter

Not me. I bought a 4 channel amp. I dont need a subwoofer. I like my music loud but care much for a lot of bass.

Mines not working at all

@BreakersStereo

Ай бұрын

Check power and ground wires

@vallenabraham4198

13 күн бұрын

Just did mines yesterday bro it's working it's probably just a wire that's not working for you