Great tutorial. Easy to follow. Thanks

@divesoflo7301

3 жыл бұрын

Glad you enjoyed it.

this was helpfull to me thank you

Nice work !

@divesoflo7301

Жыл бұрын

Thank you

Nicee...

You can get heat shrink with glue on the inside, I use it on the ends of my float ropes, good stuff

@divesoflo7301

3 жыл бұрын

I haven't seen the glue version before, that would be much easier to keep it place as it shrinks. Thanks for the comment.

@russellpurdie

3 жыл бұрын

@@divesoflo7301 no worries, it's used to waterproof cable connections

hello from iraq with you i stopping by you

@divesoflo7301

2 жыл бұрын

Thanks for checking out the video. Hope it helped you.

Will a standard hair dryer work instead? Where did you get the grip kit?

@divesoflo7301

2 жыл бұрын

The grip kit was an actual Neritic branded kit. The heat shrink you can buy from Amazon and just get some simple dyneema or thin polypropylene rope. You can try a hairdryer but you would do this at your own risk. You would have to hold the hairdryer very close to activate the heat shrink, the problem with holding it that close is there is a risk or burning the heat shrink.

Have you ever had any problems with the grip slipping once wet? Or does it stay in place?

@divesoflo7301

2 жыл бұрын

The only grip that I have had loosen up was on my lobster snare because the heatshrink was too big for the shaft. My polespears that have the heatshrink installed have not moved an inch. As long as you get the correct diameter heatshrink it will not move. If you already have the heatshrink and it's a little big, get thicker rope and it will be secure.

@kylelajot6145

2 жыл бұрын

@@divesoflo7301 thank you soo much for this, I've just started to get into spearfishing/pole spear... anywya, this video was the answer I've been searching for, thank you soo much! You have my like and sub!

Did you use the 30mm for your Neritic?

@divesoflo7301

Жыл бұрын

The heat shrink was part of a grip kit. I can look back through my order history and check.

can you use a blow dryer?

@divesoflo7301

2 жыл бұрын

If the hair dryer could get hot enough to activate the heat shrink, but if you leave the hair dryer to long in one spot you risk burning the heat shrink. The heat gun gets extremely hot and you can hold it far enough away from the heat shrink so you don't burn it. If you do not want to purchase the heat gun, try the blow dryer on a small area so you don't ruin your project. Be careful and try this at your own risk.

@juice319

2 жыл бұрын

@@divesoflo7301 cool thanks for replying