Simple...just saved me 300$...thnx

Nice video.it help me.i have a 2010 jetta and it gave me the same code it help a lot this video.GREAT VIDEO DUDE...

Nice video. And replaced the entire valve cover with new Pcv assembly. Cleaned map sensor and still have the code. Come to find out there’s a service bulletin from VW which states in higher mileage 2.5 engines (75k+) miles a software update is required. So all that work and I now have to spend few hundred for a software update. I’m gonna just live with the light.

@_DaRobot

3 жыл бұрын

I replaced the pcv valve and updated the software (technical bulletin) but i still get the code every 2 weeks :( , i have to keep deleting the code every 2 weeks. I don't know what else to do.

@mikloskiraly941

3 жыл бұрын

@@_DaRobot sounds like who ever did the software update needs to try it again. Other than that IDK

Thank you for this guide on 1 way of fixing this code. This worked for my 13 vw passat. I was having transmission issues and dealership couldn't help me so they recommended a used transmission which I sadly bought into and 1k miles later same issue. This whole issue was a stupid cap for 30$ lol may I'm so pissed that I'm out $2600.

@baxoverdrivegarage

Жыл бұрын

a whole transmission wow!! thats crazy

@ditikoci1432

Жыл бұрын

May i know what issues were you having with your transmission?? , becuase i am having also problems with my transmission i have a 2.5 golf

@zeae1183

Жыл бұрын

@@ditikoci1432 I was having issues while mainly in stop and go traffic were the transmission would hold gears then shift really hard. Also when using cruise control I was getting the same issue where the transmission would start holding shifts then shift really hard. I was told I needed to wait until it threw a code which it finally did and it was throttle body and range sensor. I replaces the valve cap for the throttle body shown in this video and it's helped a ton, it did stop throwing that code which I'm happy. I sometimes get it now but I haven't had an issue for about 2 months. I need to replace throttle body and range sensor when I get the time to or when the issue comes back. Mind you too I now have a 80k milage used transmission. My passat has 180k and it's been dealer kept since I bought it so it's in great shape

Nice video..i have the same code in my jetta and same 2.5....

Thanks! It was very useful

@hsfpiano1989

5 жыл бұрын

Did it work on you car?

bro, if you had the amazon affiliate link you could make bank I was looking for the part in your bio. Super helpful btw! appreciate it

Helpful! Thanks!

@hsfpiano1989

5 жыл бұрын

Did it work on your car?

5.1k and still counting.here before d milli

Can you please help. I did this same thing AND replaced sensor. Is there anyway new Bosch sensor is defective? I’ve seen some of them have different part numbers.

Appreciate the tip. We replaced the valve cover last year, same car, same code is back. I thought the PCV was built into the cover, so maybe it needs to be replaced once a year? I wouldn't be surprised. I have Honda's that come in all of the time needing PCV valves, at least Honda's are easy to change compared to this VW. BTW, what's with the music?

Should clean or replace MAP Sensor too.

According to O'Reilly's, replacing the MAP sensor is 68 times more likely to fix the P0106 error than the PCV valve. The next most likely fix, according to the error code diagnostic they printed for me, was the throttle body (MAP sensor about 4 times more likely to be the problem than the throttle body, still). Don't know how reliable these reports are but thought I'd share. Great video! Thank you!

@joseph-ow1hf

3 жыл бұрын

from what I've read, a failing PCV lets oil get into the inlet, so it does make sense to replace. If there is oil, one might try cleaning the MAP sensor. But if need new, luckily it's pretty cheap. Apparently the leaky PCV valve is one of the few faults w/ the good 'ole 2.5. Crank sensors are another.....and also fairly cheap to fix. Not as powerful as 2.0T, but sure a lot less problematic.

@tallterrilaw8646

3 жыл бұрын

I've replaced the sensor still have the same problem

@labilliardsgarage1944

Жыл бұрын

the reports are not reliable. mechanics are. not people that sell parts/

Should i just clean it with cleaner or how do i know i need to replace it ? Thanks

If the code doesn't go away, should I buy a new MAP Sensor?

🙌🏾🙌🏾🙌🏾🙌🏾

Would this being bad cause a leak?

i have the same problem on my 2007 VW Jetta is that and 07 VW in the video

What is that called?

I have the same problem but it comes after I drove few miles (24 Miles and up) but doesn't show any error light in the dashboard and also it start hard shifts in the gears. when ever I feel hard shifts in gear, I knew that this would be the problem. I have cheap OBD2 which clear all my car fault codes. BTW I have VW Passat B7 2015 (2.5L) US Model I haven't visited the VW yet but if there is anyone who can help me with exact part replacement ? Thanks in advance

@Mario-iy7hw

Жыл бұрын

Were you able to figure out problem with the passat? We have a similar problem same VW passat B7

@waqarthegr8

Жыл бұрын

@@Mario-iy7hw yes resolved It was getting air at PCV valve. I just checked the and fixed the pcv valve.

@waqarthegr8

Жыл бұрын

MAP sensor replacement is the last step. 1. Just check the hose connected to the PCV valve. 2. If not resolved then Check PCV valve and if required, replace it. 3. Done 4. If still not resolved then just unplug the MAP sensor and check the connectivity. If shows short circuit then replace it.

nice bro. what kind of pliers did you use for the hose clamp? is it possible to spray down the dirty original pcv with brake cleaner and reinstall?

@baxoverdrivegarage

4 жыл бұрын

kumbackquatsta think I used needle nose pliers. The pcv diaphragm is cheap, better to just buy New one and install

@sun3160

Жыл бұрын

It's not dirt on the PCV that causes them to fail. They get old and the diaphragm tears. Replacement is necessary.

the replacement dorman part... I have read .have had not so good results long term????? anyone had good long term results or just bought the whole oem valve cover with pvc attached .??????

@baxoverdrivegarage

4 жыл бұрын

Replace your Map Sensor. It's $50.

Where did you buy the spare part pcv vale?

@baxoverdrivegarage

5 жыл бұрын

rafitoon autozone

My pcv was cut, and map sensor had oil, i replace both and the code keeps coming back! Any suggestions?

@builtandraised

3 жыл бұрын

P0106 Intermittent fault with map sensor. So could be an open or short in the circuit, the new sensor you put in could be bad. Hard to diag the car without the car but just some ideas

I cleaned the sensor and replaced the PCV valve diaphragm, cleared the code and now it is back a week later, should I replace the sensor too?, the car drives normally. I just cleaned the air intake valve body and cleaned my K&N air filter and cleared the code again, to see if it is a restriction compensation thing, I don't think the sensor is bad because shouldn't the car idle be rough or something to that effect?

@baxoverdrivegarage

4 жыл бұрын

Yes replace the map sensor

@tyrian869

4 жыл бұрын

@@baxoverdrivegarage So I still haven't replaced the sensor, but like I said before I cleaned the Air intake and filter and are testing again, It's been a week so far so good, I'll keep an eye out, I will replace the sensor if I have to it is the most expensive part around 50 mucks or so, i'll post an update. hear soon.

@tyrian869

4 жыл бұрын

Okay so my OBDII reader says 0 Codes 9 ready so I think it's good? , and the car does not jerk anymore like the feeling of shifting to early, interesting results, and my driving mode lights all stopped coming on at the same time at random, I know it has only been a week an a half but those lights were coming on pretty frequently and the car drove awful before now. much smoother. so this might mean the sensor is good still.

can a dirty/faulty map sensor cause transmission issues (roughness/wrench dash warning)?

@baxoverdrivegarage

4 жыл бұрын

transmission issues?? no, i never heard of that

@mikejones4859

3 жыл бұрын

Mine has this exact issue and had this code, did you figure it out?

@mikejones4859

3 жыл бұрын

Has*

@carsonac4163

3 жыл бұрын

Map sensors measure vacuum pressure. On some korean GM cars (suzuki reno&forenza) a bad map sensor can make the car turn off or go into limp home mode. In most cars if the maps actually bad and you keep driving it then you have other trouble codes showing up

@hajrudinkavazovic2231

3 жыл бұрын

Just reset dash board light simple to do lol

Whats the link between p0106 and the pcv diaphram? Can map sensor reading can be affected by a bad pcv? I just bought a 10 Jetta put 1k on it with no CEL but have 2 dtc's P0106(Pending) P0139(stored) I belive the codes are unrelated. I think 139 was caused by a bad heated o2 sensor. I know pcv systems on these can be garbage. I did the oldschool volvo style pcv checks and the car seems to be ok. Only issue is about 4.8quarts of oil came out after about 7k -previous owner ran 6q 5w-30. I'm hoping my pcv system isnt causing oil consumption. Anyone have their opinion? Thanks in advance :)

@baxoverdrivegarage

3 жыл бұрын

Am not really sure. Am not that deeply experienced in pcv's. It fixed my issue for couple of months and i sold the car, no longer have it. I've seen some had to replace tb and valve cover for this issue alone, its annoying.

@TheJeffcurran

Жыл бұрын

The PCV diaphragm gets brittle and cracks. Then oil vapor gets into the intake and builds up on the map sensor causing it to fault out of range.

Dont you need to clean the map sensor to wipe the code?

@baxoverdrivegarage

5 жыл бұрын

Shannon L tried that at first but that didn’t work

@eluna58

2 жыл бұрын

@@baxoverdrivegarage so you had to Replace the MAP and the diaphragm for it to work?

Nicely done. Do you need a scanner to clear the codes, or can you disconnect the battery for a few minutes?

@baxoverdrivegarage

5 жыл бұрын

Yeah you’ll need a scanner, or you can just drive for some miles and it will go off by itself

@jimjensen1096

5 жыл бұрын

@@baxoverdrivegarage Great. Thank you.

So this cleared your p0106 code? Without cleaning or changing the map sensor?

@JoeSmoeDoeLow

3 жыл бұрын

It might clear it. I changed my Map sensor and still have the code. Were you able to fix your issue?

@AfternoonProductions

3 жыл бұрын

@@JoeSmoeDoeLow Did you try cleaning throttle body? I have the code intermittently im going to try that this weekend. Changed pcv and MAP still comes back randomly

@JoeSmoeDoeLow

3 жыл бұрын

@@AfternoonProductions Thanks for your reply! I was able to get the code to go away by cleaning the throttle body, replaced MAP sensor, and changed PCV diaphragm. Found a little oil in the intake manifold and cleaned it up. Also cleared the code using my OBD2 scanner. Been driving for 200 miles and it has yet to come back.

@AfternoonProductions

3 жыл бұрын

@@JoeSmoeDoeLow no thank you for replying!! This code has been driving me absolutely crazy!! I will update you this weekend. I should have just cleaned the throttle body when i did the MAP and PCV. They were both a little oily

Hello, what's the actual name of the replaced part? Thank you!!

@johnnewell2495

5 жыл бұрын

Dorman 917-064 PCV Diaphragm

@joshuabaser785

3 жыл бұрын

It is called a manifold absolute pressure sensor

@csoled11

3 жыл бұрын

@@joshuabaser785 thanks for replying Joshua. I thought that was the part that was wrong with my car, but I took my car to VW for a check engine scan and my trouble was the Throttle body.

@brucecava

Жыл бұрын

@@csoled11 I have a throttle body code. did you need to replace your throttle body and was it easy? Or did you just clean it?

This is great if i wanted to to to a Club.................

1:42 pull off cover from left side (stands on right side)

Sorry but he is not changing the right part for that coad

Should be titled: how to get scammed by garage KZread star. 1/70 times this fixed my problem........

That’s not the sensor. Everybody in the world wants to make a damn video

@baxoverdrivegarage

4 жыл бұрын

your247support and you have a problem with that? It aint ur camera why should it bother u? No one forced u to watch the damn video. I changed the map sensor and diaphragm which fixed mines.. take yo negative ass somewhere else

@sthom146

3 жыл бұрын

@@baxoverdrivegarage Come change mine please😂🙏🏼

I HATE THIS F....MUSIC!

Worst music ever. Makes it hard to concentrate on the video.

@baxoverdrivegarage

5 жыл бұрын

Mike Grosse well if you can’t concentrate on the video then don’t watch it. No negativity here

@ambersmith200

4 жыл бұрын

hit the mute...SIMPLE!!!