Excellent video. The music drove me crazy though.

@RegsChannel

6 күн бұрын

@@binnsbrian thanks for the feedback, hope the video helped!

Hooray for Reg's wife! Hero of the video, putting in that work!!!

@RegsChannel

Жыл бұрын

I couldn't have done it without her!

Great video!

@RegsChannel

19 күн бұрын

Thanks for the kind words!

As always super well detailed step by step video, keep 'em commin' so informative!

@RegsChannel

Жыл бұрын

Thanks for the kind words as always! Will do!!

This is amazing, kudos to you and the wife for knocking this out!

@RegsChannel

3 ай бұрын

Thanks for the kind words, much appreciated!

Awesome I wanted a basic idea and great I feel confident enough to try this with mine. Great video

@RegsChannel

8 ай бұрын

Thanks so much for the kind words! Good luck with your project

Excellent video Greg !.... I'm going to try this on my pool.

@RegsChannel

3 ай бұрын

Thanks! Hope it helps! It's held up great so far!

Can you use lightweight concrete and just build pillars ?

@RegsChannel

19 күн бұрын

I'm not too sure how to do that tbh, you still need to be able to get the pool deck level and don't have a ton of room to operate.

Nice stuff man, this looks heavy duty to do. How did you decide you need to run this across the entire perimeter of the pool vs a small area? Is it best practice to check the entire perimeter?

@RegsChannel

2 ай бұрын

Hey there! Thanks for the kind words! For me, I had a visible slope on each side of the pool deck, if you check out my OG video in the series I had leveled the opposite side that was way worse a few years earlier. For sure check the entire perimeter. Remember a bit of a slope is ok, but if it's like 4+ inches over 2 feet of pool deck that's too much! LMK if you need any advice along the way.

do you have a link to your extention tube you used

@RegsChannel

3 ай бұрын

This is similar to the one I used. In your hardware store open the spray foam container and size the PEX pipe to nozzle tip, that should help! www.canadiantire.ca/en/pdp/waterline-flexible-lightweight-pex-pipe-white-1-2-in-x-5-ft-0631419p.html

You might also consider construction grout instead of foam. It’s a bit cheaper (here at least) and is made for filling in voids like that. Nice job.

@RegsChannel

11 ай бұрын

Thanks so much for the kind words! That's something I would definitely look into! Cannot be applied in a similar manner?

@bdpgarage

11 ай бұрын

@@RegsChannel it’s possible to pump it in with the right equipment, but it flows like a runny cement so you can pour it in at the back of the slab and it’ll rise up and flow into all the nooks and crannies. You just have to form out the back so it doesn’t run out the back part that you lifted.

@RegsChannel

11 ай бұрын

@@bdpgarage I see, based on my situation you would you get the construction grout in the void then? Drill holes in the top of the pool deck near the wall and then flow it in that way while making a form around the edge of the pool deck? My only concern would be the additional weight of the construction grout causing additional compaction. Good to hear of another alternative though!

@bdpgarage

11 ай бұрын

@@RegsChannel you could drill holes, or just pour it in from behind. Thats why you need to form up the “lifted side” so the grout doesn’t run out. I left about an inch gap that I could pour in.

@RegsChannel

11 ай бұрын

@@bdpgarage sorry I'm just not visualizing the "pour it in from behind" part the only open side is the low side that would need the form applied to. The steel wall forms the high side, and the edge of the concrete is the low side.... Hope that helps!

This happened to an area of my pool deck here in Florida. Only problem is my deck meets my lanai so I cannot dig it out

@RegsChannel

4 ай бұрын

What you could do is look into getting it mud jacked. Basically they drill small holes in the pool deck and then pump in a mud slurry that actually lifts the slab back up. The challenge though is that sometimes the slurry could push on the pool wall, that is what happens to me when I recorded the original video (check out my channel to see that one) and made me jack up the pool deck. Good luck with the repair, it sounds difficult but not impossible!

@audreykassem8010

4 ай бұрын

@@RegsChannel ok I will review your video. Thank you

@RegsChannel

4 ай бұрын

You are welcome! Good luck with the repair. let us know how you make out!

Why not put concrete back in? I have to do this to my deck

@RegsChannel

19 күн бұрын

You could but you need to have it be able to flow uphill to address the settled void. Also if you need to access plumbing in the future you ideally don't want it encased in concrete. Hope that helps!