Good video. Every GoPro user should get to grips with Labs. Makes a massive difference to the footage quality!

Great Video Markus, and thank you so much for helping me out with my setup of the camera (first time) 🙌🏻

Thanks for the video, love the norwenglish. I will remember to smear myself with a little patience 😂

Very nice video!!! tnk u. I want to record metro , to go on all the stations, but i don t know what settings to make ....:( I have GoPro Hero 11

How can I check my changes in GoPro Labs? The settings are visible for a moment after turning on the camera, but how do I check them later?

@MarkusFinholt

6 ай бұрын

You check them when you turn on the camera.

Hi, when I buy a new GoPro 12 Black, do I have to install some newer firmware and then install GoPro Labs or is only Gopro Labs enough? Thank you

@MarkusFinholt

Ай бұрын

Just installing the most recent gopro labs firmware is enough

Any chance you could make a video on how to set up the GP11 to use the GP-LOG LUT from the GoPro and how to get the best results with it in CapCut?

@MarkusFinholt

2 ай бұрын

No, sorry.

Thanks for the good video. When I use the QR Control app and change DAMP , EXPX and other settings and choose it to be permanent. Then they change back to "0" afterwards. Why? Or what am I doing wrong?

@MarkusFinholt

6 ай бұрын

Sounds like user error, but could be incompatible settings with certain gopro models. Or a wrong firmware version.

Hi! On reddit you said that the best signal to noise ratio for NR01=50. Why are you now saying that you need to turn off noise reduction? What changed?

@MarkusFinholt

6 ай бұрын

You've mixed things up a bit. Signal to noise ratio (SNR) is something else that relates to how much noise there is compared to the input. In gopros case, the signal always creates a certain amount of noise in relation to the signal. Some of that noise gets reduced with in camera noise reduction. Setting the NR01=50 will allow 50% of that noise reduction to be applied, even though the original amount of noise affects the image before the noise reduction is applied. I said to set it to NR01=50 if you want to do minimal processing like me. This allows me to not have to use noise reduction in post, because I find the amount of noise to be acceptable at NR01=50. If you want the purest quality you can choose NR01=1, but then you might have to use noise reduction in post.

@andreybear

6 ай бұрын

@@MarkusFinholt I understand! Thanks for the detailed explanation!👍

Hi Markus, The noise reduction setting should be set to NR01=1 right ? and not NR01= 0 3:49

@MarkusFinholt

7 ай бұрын

In the app it says 0 disables the setting. But at the same time it says 1 leaves the most noise. So I'm not sure if it's 1 or 0. Do some tests and try it!

@sakthimurukanpalanisami8308

7 ай бұрын

I did run some tests and found that NR01=1 setting is the one to turn off noise reduction and not NR01=0. Great video by the way. Cheers

@0dan0

6 ай бұрын

@@sakthimurukanpalanisami8308 Correct !MNR01=1 is the most noise, the least noise reduction. All defaults are 0, so NR01=0 or BITR=0 is the default for those features, non-zero values enable the feature.