How to Cut and Bend Downpipe Ends for a Shed or House - D.I.Y Roys Sheds
Тәжірибелік нұсқаулар және стиль
NOTE: Always work on the small end of the downpipe (AKA downspout) - there should be a dimple indicating the small end.
If you like these types of videos and would like to see more of them, please like/subscribe and let us know what you would like to see :)
This video demonstrates how to cut and bend downpipe ends.
Please let us know if you have any questions or if you have any recommendations.
--
Perth Wide Custom Steel Shed Suppliers and Builders
Website: royssheds.com.au/
Phone: 08 6230 2250
Online Quote: royssheds.com.au/request-an-o...
--
Required Tools:
- Combination Square
- Pencil
- Left & Right Snips
- Drill
- Pop Rivet Gun & Rivets
---
Song: Flying High by Fredji @fredjimusic
Music provided by Free Music for Vlogs • ** No Copyright Music ...
Пікірлер: 26
Mate these videos are gold thank you very much
The high speed overview at the very start was perfect. Good to know what the video is about I probably could've made it off that alone.
Thank you, well done, plain and simple.
Roy needs to make more vids - AWESOME VID!
Excellent use of angles and creativity!
Pure artistry wow perfect cut
Very helpful. Thanks !!
just what i needed, cheers.
Brilliant!
Thank you
Thanks 🙋♂️
Parabéns aqui no Brasil fazemos assim
Is there a vid on how to do this on a round down spout
We used a machine, I think it was called a miter biter. We soldered the joints. Galvanized.
What are the measurements for the lines you drew?
How do you get the right angles? Some pipes may be different angles when they meet up
Does this make a 45degrees?
Does 25mm from the line work for every size of downspout?
@wingmanmedia360propertybus4
2 жыл бұрын
I needed to make a slightly more than 90 degree angle and I had to cut much more than 25mm. If you ok with a grinder or with a scissor cutter it is better to cut less as you can always cut more to adjust to reach an angle you want. In my case it has taken four times or cutting extra. If you overcut you just ruin a downpipe. I think a decision on how much to cut depends on a height of a pipe and an angle required. I think if the pipe is 80mm in height and you need to get a 90% angle you need to cut half of 80mm which is 40mm.
How do you measure from the gutter to the wall?
@RoysSheds
5 жыл бұрын
Hi Silas, are talking about a gooseneck downpipe? We are in the process of editing the video, I will send you a message once we upload it.
@RoysSheds
5 жыл бұрын
Gooseneck downpipe video: kzread.info/dash/bejne/h5ustJamgq7bk8o.html
What size rivets??
@RoysSheds
Жыл бұрын
4-2 rivets, 3.2mm thick x 6.4mm long