How to check loadcell wıth multimeter on MEKA concrete plants?
Ғылым және технология
In this video we will show how you can check loadcells with multimeter
Concrete Plants
► bit.ly/2nNsEuh
► Don’t forget to subscribe
bit.ly/2LhRCLu
ALL VIDEOS ►bit.ly/2KBPChw
Ready Mix Concrete Plants
► bit.ly/2LfJXvR
Concrete Batching Plants
► bit.ly/2qgiuTQ
Concrete Technologies
► bit.ly/2PPSr00
► Follow our official page on LınkedIn:
bit.ly/2X8cDiT
► ► MEKA Crushing & Concrete Batching Technologies
www.mekaglobal.com/
Mobile Concrete Plants
► bit.ly/2oKOfE4
Пікірлер: 7
excellent explanation, best impossible greetings from venezuela hits on your channel
please explain how to test the load cell and the adding card using a voltmeter thank you very much
@alexeiiudin7532
6 жыл бұрын
Hola Alexs, in this video they are using a Multimeter, which is also called a Multitester or VOM (volt-ohm-milliammeter). You need to measure the impedance, not the voltage, as only impedance can indicate the potential problem inside the loadcell.
@alexscastellano5806
6 жыл бұрын
Greetings alexei Iudin I ask this question why the load cells have a parameros that is expressed in mv /V and, there is a way with an answer in mv taken with a voltmeter could you know if the card added or the load cells are damaged
@alexeiiudin7532
6 жыл бұрын
You are talking about the Zero Balance test. It is also one of the ways, but it doesn't always give good results.
@alexscastellano5806
6 жыл бұрын
ok thank you very much with the advice you could help me if you have information on how to test speed vibration sensors, acceleration using a multimeter
Ye Kitna ton ka Loadcell hai.