Thanks man! You showed me exactly what I needed to know plain and simple...

Thank buddy! Good video 😎

So funny, I was looking at one of those a couple of hours ago. My lucky day to find your vid.

@OutofWORKoutdoors

10 жыл бұрын

yes. i did too but no one had a video out for me to find.

Nice install bud!

Good job..

What that piece that locks the outboard to the transom called? Did you made it or bought it?

What size of cable for the bilge pump please

Thanks for making this video. I’m looking for a similar solution because I also don’t want to drill that hole in my hull. Can you let us know where you got those rubber hose clamps? Cheers

@OutofWORKoutdoors

4 жыл бұрын

can't remember where i got those

Where can I find the braces you uses for the drain hose and what size are they and what are they called

Is the pump automatic?

How many thumbs do you have?

I like that you didn't drill through the hull, yeah it might not look as clean but once you put holes in Aluminum it will never quite be the same as factory. Then you're constantly having to go back and repair leaky spots with Silicon junk or some other sealant. I feel you should never put holes in your aluminum boat hull if you don't have to. One consideration I might have is stuff bouncing around in the back of the boat and knocking into your pump, breaking it. If you always drive on smooth roads maybe no issue but I've seen deep cycle marine batteries slide around, gas tanks get knocked around on some bumpy back roads when that trailer starts bouncing. My thing would be to ensure stuff is secured down tightly.

I'm new to the hole boating thing. What is the bus bar for and how do you hook one up. Thx

@OutofWORKoutdoors

10 жыл бұрын

bus bar is to distribute power to the switches.

nice video, looking to do the same type of wiring that you did with the 7 switch panel... Where did you get yours from?

@OutofWORKoutdoors

9 жыл бұрын

got it from ebay believe it or not for about 45 dollars

@doodoobrown3928

9 жыл бұрын

+OutofWORKoutdoors you know you can make your own for like 20 c a switch?

is everything connected to one battery? engine, trolling motor, fish finder, bilge etc. Thinking about upgrading my jon boat, should I have a battery in the back for the engine and another battery up front front for fish finder, trolling motor, and bilge?

@OutofWORKoutdoors

10 жыл бұрын

i have everything wire to one battery and it can do a full day on a full charge(24 size battery). The trolling motor is wired directly to battery with a 30 amp breaker. All other electronics are wired from the bottom switches. My engine is a hand start so i don't use my battery to start my 9.9 hp engine. I just put most of the weight in back to help with the speed of the boat as it's travels. i can hit about 17 mph with two people on board.

Did the gas tank jump around and “Unmount” the pump?

I put probably a little too much thought into mounting mine lol . All 3/4 pvc

@alexkoenig4893

7 жыл бұрын

I also only have a 3 switch penal with a USB port so I can only turn the pump on when I turn my stern lights on because I ran out of switches and i have still yet to hook up my amp and Bluetooth receiver so I'm gonna have to figure that one out too. My advise is to get more switches than you think you'll need

frame a deck and boat carpet that sum bia!

What’s the intro song

Is it a automatic bilge pump? Didn’t see a float switch

@OutofWORKoutdoors

3 жыл бұрын

Manual pump tied to rocker switch