Thanks for all the info and descriptive breakdown and rebuild! I will eventually have to do this. Thanks for sharing this with us! Your awesome!!

Well done, looks and sounds great. Saved a ton by doing it yourself and the satisfaction to now it was done right.

Definitely a big job for sure, glad to see that you tackled it. Thank you for posting.

@NuttyNu

Жыл бұрын

Thanks for watching!

Tremendous project and video. Thanks for showing us

@NuttyNu

11 ай бұрын

Many thanks!

That's over 2000 at the shop and you sure need a trustworthy mechanic on a job like that. I'm impressed with your skill here little nutty buddy. Trapper scotty

awesome video! you're convincing me to do this myself. I've only gone as far as replacing the valve cover. How was the surface on the block side? It didn't need to be resurfaced?

@NuttyNu

5 ай бұрын

it was fine, I cleaned the block's surface with a

How’s the difficulty compared to the 3RZ? I’ve also done a 3rz and it wasn’t too bad. Looks to be a very similar layout (3rz and 1fz).

@NuttyNu

2 ай бұрын

Much easier on 3rz, the 1fzfe just has tight spot on the intake side/driver side

Hey Nu, i been following u for a while now. But havent respond back to any of ur video. I just got ask though, with the 2k range building up the top half. Would it be better just to swap the engine out for a 2uzfe or 1uzfe, Keeping it toyota. Im in the same boat, i got my LC80 8 yr ago with a knock, but i did the bearing from underneath do to the heavy engine. But after the bearing, it drive point A to B but its still have the knock on cold start. W gas in cali 6$ a gal, Thinking about yanking the 1fzfe engine out. Wats ur thought on the 1fzfe vs 2uzfe. Thanks for the good vid on LC80

@NuttyNu

2 жыл бұрын

hi, I dont have any experience with those two motors/ swap. so I couldn't give you what I think, I would say if you have the budget and knowledge to do the swap, Go for it! the 1fzfe, is expensive to build now and hard to find parts for. keep that in mind.

@ongmoua1077

2 жыл бұрын

@@NuttyNu NP buddy, i been debating on yanking the 1fzfe out. but just thought i ask. n yeah these 1fzfe is pretty expensive in parts. 8 year ago i replace the rods bearing. 1 set oem rods bearing cost about 100 bucks, but its all good. 1 way find out is do it urself. bside i have 1 extra 1fzfe on the side too which not sure if gonna put that in or go 2uzfe. thanks for the straight answer. keep up w the good YT video on the 80's series. good chatting w u. TK

Was this alot harder then the tacoma 2.7?

@NuttyNu

9 ай бұрын

Yes. More complex

Hey Nu! Can you replace my water pump and timing belt for me on my VW!?😅 I'm out in the valley, the car gets better mpg than my Silverado.

@NuttyNu

2 жыл бұрын

No

@jamessantiago9724

2 жыл бұрын

@@NuttyNu that's what I told myself!😅

Over 200,000 I replace motor top be bland new and lower motor have over 200,000 I do a motor

PO payed $550? Holy Chit 🤣🤣

@NuttyNu

2 жыл бұрын

The homie discount.