A video of a man who hasn't serviced one of these hubs for a long time and it shows.
Hope Pro 2 rear hub requires a total of 5 bearings.
2x 6903. (17 x 30 x 7)
1x 6902 (15 x 28 x 7)
2x 6802 (15 x 24 x 5)
Don't forget to replace the washer!
Time stamps:
00:00 Intro
00:25 End cap (Silver)
01:50 Freehub removal
02:00 Washer
02:20 Freehub pawl & spring removal
03:10 Labyrinth seal removal
04:00 Tube in the middle needs to move
04:30 Freehub bearing removal 01 (6902)
05:50 Freehub bearing removal 02 (6802 x2)
07:05 Wheel hub bearing removal with axle (non drive side)
09:38 Wheel hub bearing removal from axle (Probably a better way?)
11:48 Wheel hub bearing removal (drive side)
13:40 All stripped? (I think)
14:13 Bearings needed?
14:55 Clean up the freehub
15:22 I messed up and forgot the tube
15:30 Installing bearings & tube in freehub body
17:10 Make sure the central tube can still move
17:38 Wheel hub bearing install, drive side (Lost footage of the 2nd small bearing being installed on freehub body)
19:00 Visual check of how the drive side bearing sits
20:30 Axle installed & non drive side bearing
21:22 Visual check of how the non drive side bearing sits
22:27 Axle needs to be visible
23:34 Freehub pawls and springs
26:20 Ratchet demo
26:45 Installing labyrinth seal
27:26 The washer (There's a good chance you forgot this)
27:38 Installing freehub body to wheel hub
28:10 End caps
29:32 Finnish
29:46 I did tidy up the end a little bit