No video
Home made power feed for a mobile band saw mill
A few people have expressed interest in seeing how I set up my power feed on the mobile band saw mill. This is the current setup I am running. Please keep in mind that the mill is not quite done yet, so I have not yet been able to test it on a log. So, whatever information you may glean from this, just take it with a grain of salt.
I understand that there may be some problems with this setup, and I'm always open to constructive criticism. Please just keep the comments civil.
Пікірлер: 19
Good work on your Mill. Hope it will be all fine. Builting m'y own was the nicess thing I have done its very rewarding when everything comes togeter !
Thanks!
thats a sweet setup man. Im going to emulate that on mine. was pouring over wheelchair motors which I dont like the idea of anyway and harbor freight is right here, like to see some more nfo on the fabrication of the #40 chain sprocket onto the winch..
Where can i buy ?
How wide is that pallet rack
Thanks for the video! Looks great. I bought a cheep speed control like you and it has issues when wired up and switch off it’s putting 10 volts to both sides of the motor? Probably bad? What size wire did you use from the controller to the winch motor? It seems to be be kinda light duty for a sawmill? Thanks. Needing some advice from Arkansas.
@seanjmichel
Жыл бұрын
Believe I ran something like this. Believe I ran 10 or 12 ga to the winch. a.co/d/jdTh2hz
@robertsprafke9376
Жыл бұрын
@@seanjmichel thanks!
Why not use a solar powered charger to keep the battery fully powered?
Can you tell how do you cal
@seanjmichel
Жыл бұрын
cal? as in calibration? hey please let me know.
Curious to know where you're located. Thanks. David Michel
@seanjmichel
2 жыл бұрын
I'm in nassau county, NY. Country boy at heart. Will hopefully have footage in the adirondacks this summer.
@TheOldManAndTheSaw
2 жыл бұрын
@@seanjmichel Just curious because you have an unusual last name. I'm just north of Syracuse, in Parish.
@seanjmichel
2 жыл бұрын
@@TheOldManAndTheSaw hmmm yeah I've never met another person with my last name. I do not know of any relatives from that area. I know my grandfather was from Brooklyn, born around 1909. Don't know much else from that side of things.
@TheOldManAndTheSaw
2 жыл бұрын
@@seanjmichel Check to see if your grandfather had a Francis or a Lawrence as an older relative in the family.
@seanjmichel
2 жыл бұрын
My father said he doesn't think so but that doesn't mean it's impossible.
Just curious do you still run your mill today?
@seanjmichel
5 күн бұрын
Yes I do. Have made a couple mods, but it runs great