हिंदी में - Led night lamp Diy directly with 220 volt AC
📱"🔔" -
👉 Join Telegram Channel - t.me/craftocurrency
Like ♥️ Share & Subscribe 😊
Thank you for Watching 😃
#diyledlight
#diyledbulb
#diylednightlamp
#diyledproject
#diycrafts
#diy
#diyhomedecor
©️ Disclaimer
Copyright Disclaimer under Section 107 of the copyright act 1976, allowance is made for fair use for purposes such as criticism, comment, news reporting, scholarship, and research. Fair use is a use permitted by copyright statute that might otherwise be infringing. Non-profit, educational or personal use tips the balance in favour of fair use.
ㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤ
Song: Jarico - Landscape (Vlog No Copyright Music)
Music promoted by Vlog No Copyright Music.
Video Link: • Video
Пікірлер: 37
Super project sir ji
Very good job. Simple and economic project.
@Craftocurrency
2 жыл бұрын
Thank you very much 💐
Nice work 👍
Bahut hi badhiya hai 👍
@Craftocurrency
2 жыл бұрын
Thank you 💐💐💐
Nice 👍
👍
Super
@Craftocurrency
2 жыл бұрын
Thank you
Please show the ckt with all connection, if possible...
@Craftocurrency
2 жыл бұрын
Ok sir... Apni amar telegram channel e aste paren.. t.me/craftocurrency
Heavy Glow chahiye to kya karna padega?
nice
Nice
@Craftocurrency
2 жыл бұрын
Thank you 💐
Can I use 56k registans
Agar ham isme 10 led laga de to kya ye chalega
@Craftocurrency
2 жыл бұрын
10 LED series में लगाकर केवल मात्र रेजिस्टेंस को 68 kohm कि जगह 22 kohm लगा दिजिए। बाकि diode का कनेक्शन वहीं रहेगा
Zasto nisi napisao vrijednost otpornika
@Craftocurrency
2 жыл бұрын
I have shown the value of resistance on the video. please watch the video again.. Thank-you
@mbzumzum500
2 жыл бұрын
@@Craftocurrency ok,upravu si...hvala..imas lajk
@Craftocurrency
2 жыл бұрын
@@mbzumzum500 Hope you have seen all my videos. If there are any errors in the videos, please let me know. Your comments are important to me. Thank you very much again
LED - + connected diode not need and no action.
@Craftocurrency
2 жыл бұрын
The only reason to use a diode is to extend the life of the LED Thanks for watching the video 💐
@mr.bullet6844
2 ай бұрын
@@Craftocurrency@Craftocurrency Hi sir hope you are fine. Sir I found your video today I followed it and made a circuit as you did. Sir my question is that you used a diode for the led and said that it'll extend the life of the led. Could you please explain this point. How this diode can protect it's life. I am 1st year student in electronics engineering. Please reply and explain it for my knowledge. Thanks in advance.
2 led ka kese bnaege
@Craftocurrency
2 жыл бұрын
पहला LED ज़हां मैंने जोड़े हैं उसि जगह दूसरी LED जोड़ दिजिए
220vlt pe id jata hai led
@Craftocurrency
2 жыл бұрын
You make this project. If you are not satisfied with the fabrication then you can tell me. But do not use vulgar language in words.
@SandeepKumar-dl5ml
2 жыл бұрын
I have checked every thing registans blast
@Craftocurrency
2 жыл бұрын
@@SandeepKumar-dl5ml I can't believe it. 🤔 Probably due to the wrong connection the resistance exploded. I do not upload fake videos. I am lighting this led light in my own room. Try it a second time and you will succeed. Best of luck. Have a nice day 💐
@SandeepKumar-dl5ml
2 жыл бұрын
Can I use 56k registans
@Craftocurrency
2 жыл бұрын
@@SandeepKumar-dl5ml Yes, 56 ohm resistance can be used. It is better not to use it below. Using resistance below this can damage the LED.
Poor workmanship
👍
@Craftocurrency
2 жыл бұрын
Thank you 💐