Hilti DX A41 Fully Automatic Powder Actuated Tool
First of the low velocity powder actuated tools. Hilti is still the only company with a fully automatic tool that is decent. Don't waste your money on a magazine tool that only holds ten pins, the added aggravation of dealing with pin jams isn't worth the cost. I mean really, it only holds ten pins. Is it really worth extra money to load ten pins at a time when you need to stop and fiddle with a pin jam on a consistent bases?
Пікірлер: 11
Hi there can you please make a video on how to dismantle the DX a41 with the magazine X-AM72 and service. This one is very useful but the actual part of dismantling is fast forwarded. Please help as there are no other videos on this model. At least not as well explained as yours.
@vintagepowderactuatedtools9036
3 жыл бұрын
There are several reasons why I'd rather not, a big one being it complicated and special tools are required to do the required maintenance work. It really should be done by technician trained by Hilti and I am not that person.
exxelente y objetivo video , gracias x compartir su experiencia maestro ; una duda vi a una HDX460 perforar viga d metal, Q otros modelos podrian realizar lo mismo ? Y como ud. comenta sin gastar dinero extra en aditamentos q tarde o tempranp provocaran alguna falla . b ns
@vintagepowderactuatedtools9036
Жыл бұрын
If I understand your question right, the maximum penetration is about 10 mm.
I have a question.. so I have the dewalt p3500 ..so I took the entire gun apart and put it back together fine thanks to your DX350 break down video . But I tested it today with only 2 shots because of the area I live in I couldn’t test a lot and it worked perfect very powerful ..but it had a lot more smoke coming from the gun then I was use to seeing but the second shot did have least smoke .....my question is do the smoke mean anything although I’ll run a couple clips thru the gun tomorrow at work to see if it continues. Is it a problem
@vintagepowderactuatedtools9036
3 жыл бұрын
You are just burning off excess oil, nothing to worry about.
@bankhead39
3 жыл бұрын
@@vintagepowderactuatedtools9036 ok thanks 🙏
Hi there can you please tell me if this model DX A41 uses the same piston as the DX 460 as I'm looking at buying it second hand from my Mate. Cheers
@vintagepowderactuatedtools9036
3 жыл бұрын
no they are different, it will not work
Why would you fast forward the disassembly? It’s the part that was useful! Dang it.
@vintagepowderactuatedtools9036
2 жыл бұрын
Because the video was already too long. All that happens during the fast forward parts is I removed two screws and the outside covers. The second fast forward part I reinstalled the covers and screws.