Switching using a p-type MOSFET. It is called high-side switching because the MOSFET switch is connected to the voltage supply.
Жүктеу.....
Пікірлер: 2
@rlliston16488 ай бұрын
Very informative! Thank you! What software are you using?
@waterfuel7 ай бұрын
########Seems likely I can still use Vcc 12v and reduce with voltage divider for use with N channel Mosfet and load, as HIGH SIDE SWITCHING. My test load is a coil, which in formula does not use voltage, only current , inductance and fast time in seconds. Circuit can use 9v or less to operate with Gate drive from 12volts DC. The N type has a lower "on" ohms resistance. P type can be used with it's higher ohms, as long as the current is very low, for lower waste energy heat.>>>>>>>>!!!
Пікірлер: 2
Very informative! Thank you! What software are you using?
########Seems likely I can still use Vcc 12v and reduce with voltage divider for use with N channel Mosfet and load, as HIGH SIDE SWITCHING. My test load is a coil, which in formula does not use voltage, only current , inductance and fast time in seconds. Circuit can use 9v or less to operate with Gate drive from 12volts DC. The N type has a lower "on" ohms resistance. P type can be used with it's higher ohms, as long as the current is very low, for lower waste energy heat.>>>>>>>>!!!