Great prints Paul

@knoxieman

4 ай бұрын

Cheers bro

Excellent, well thought out design. Thank you so much for the design and gifting your time and effort to the community.

A very nice case, and very kind of you to offer the files for free. Thank you.

This looks brilliant! I'm going to print this later.

Thanks for the stl's from South Carolina USA. Printing now as I type this

I downloaded the STL as it's a brilliant case but unfortunately they guy I had on tavistock to print it butchered it by used cheap filament on a low resolution printer and charged me over the odds for it haha currently go it in my loft but held together with gorilla tape as needed it in the loft, thank you for sharing

Cracking stuff. We (our local ham emcomm group) has created a mesh just this last week on the South and East of Sheffield. I've just today got a 3D printer to play with and your case HD base is my first attempt at a 3D print ever. I used CURA to slice the design and my printer is an Ender 3 S1 Plus. After a bit of a ropey start (I think I still need to adjust the Z offset) its about 71% of the way through the first print. I've used the standard slice profile (read your instructions after the fact) but it seems to be OK. Thanks for doing these designs, Top Man!! BTW subbed you just for the effort! ATB

Nice tidy units these👍🏼

I have the 3000 mah batteries. I am currently testing the helium type antenna with 5.8 dbi gain. putting it up on the roof this weekend.

Thanks ❤

Thank you so much for the work and files. I love this case. I have mine setup with the same battery but get some strange results with the Voltage and Percentage readings. I know about the ADC multiplier but cant seem to get it just right. Did you have this experience with yours? Thanks again.

Hi Just printed the case, looks good but cannot find these switches on amazon. have you a link.?

Hey, Do you know if a Micro JST 1.25mm connector battery will directly fit the Heltec? If not what connector does it use?

I would love this case but I don't own a 3d printer

Does heltec board control charging process of connected battery?

@knoxieman

3 ай бұрын

Yes