Hand Engraving - How To
www.aajewelry.com - This is a step-by-step instructional video. The video explains the proper procedure of hand engraving. This video also describes how the graver is prepared and informs the audience of what tools and supplies are used for this project. Work done by: Sam Alfano.
Пікірлер: 28
Excellent brief visual and verbal explanation!
Very cool and good information. Thank you for sharing
Beautiful work!
Thanks for sharing.
Pertanyaan saya jika kita mengukir coin seperti di vidio anda apakah menggunakan pahat yang lebih dari ukuran standart?
Diamond spray sounds pretty cool.
magnifique
Hey not sure you check comments on here often but as someone learn g to engrave and being left handed would it just be the opposite with a flat? As a righty your cutting with the left corner of the graver from top to bottom on the beauty line. As a lefty would I use the right corner and cut from bottom to the top? Or is that not the correct or best approach? Any tips or pointers are appreciated! Thank you in advance
absolutely beautfiful -mrs stockford
hello podria decirnos o mostrar cual es la maquina que produce la vibracion al momento de grabar?? thanks!
Great video! Gravermax: $1200, compressor: $2000, air filter: $100, handpiece: $300. Around $3600 for the whole thing :-|
@ALSomthin
3 жыл бұрын
Dont forget the microscope!
Where could I get the tools to do that?
WOW
Gravermax grs es la maquina
Ye wala kaha melega machen
Hallo; Im Hassan from Moroco I mak Handengriving and I searsch a work.
Ok, so I need to buy a gravermax. #noted
I want one of those penny's.
Using gravermax is not my idea of hand engraving. For precious metals especially its unnecessary expense-invest in hand gravers and learning to use them well instead. It is no more time consuming or difficult once you know how
@Brentcolo
10 жыл бұрын
What tools do you recommend?
@artbyrobot1
8 жыл бұрын
make your own tools in my opinion
@Brentcolo
8 жыл бұрын
I agree
@cazlane
8 жыл бұрын
In answer to your previous question (2 whole years ago - my! Lol ) Glardon- Vallorbe are a make of Swiss gravers offering a comprehensive range...a bit of research should guide you best for what you want to do. You will need to buy handles and modify length to suit your hand-it's easy to do...place pointed end down in a bench vice at required point then smack smartly with a hammer to remove excess length...regrind handle end to sharp enough point then back to vice to tap on handle et voila...your own customised hand graver
@asmrdazzle
Жыл бұрын
Hi Caz- I’m learning both currently and I find hand gravers much easier than the air graver but the wrist and hand pain is a huge difference between them. Do you have any recommendations for pain while hand engraving?
Is that Joe Rogan speaking ?
Graver max are for amateurs