Guide: How To Lay Underfloor Heating
Learn how to lay underfloor heating from an expert. Underfloor Heating Systems Ltd have years and years of experience laying warm water underfloor heating. Includes information on every process from preparation work and products to used to finishing touches.
Пікірлер: 32
probably the most detailed UFH installation video ever seen
With the use of FlooriQ Milling Machines, this process is made even easier :) great video, thanks for uploading x
Very helpful in helping understanding and construction.
When you mention the edge insulation, if this sits on top of the base insulation, then you ad the dpc membrane, does the blue expansion edging go against the wall as well as or instead of the kingspan? From the concrete wall inwards, is it: 1.Wall, kingspan edging, membrane, Blue expansion strip, floor screed? or 2. Wall, membrane, blue expansion strip, screed?
On the blender joint under the pump is the flow inlet from the boiler below and the return to the left ??
a great video...
Dear Expert , Thank you for the brilliant explanation. My question is whether we can install new laminate on top of old ceramics while using a wet floor heating system. Could you please guide me on whether this would prevent efficient heating conductivity, increase energy consumption, and how it might affect moisture levels? Additionally, what steps can I take to control these factors? Best regards,
Hi. Is it posible to heat shower floor? And all bathroom?
Damn, I wish you are available in my country
هذا عمل جيد جدآ
Is is sortable for laminate floors? Please if anyone know
Welcome if you can send details about this company and address Is there a branch of the company in Iraq Basra
Ccokk güzel ya
@MarcelHVAC
6 жыл бұрын
yok
Yesterday my builder applied 100 mm screed...is it ok??
@ajmalshabir4089
3 жыл бұрын
It will take longer to get it warmed will certainly decrease the effectiveness but don't worry it will do the job
@AN-ks2ep
2 жыл бұрын
yes, we have close to 5 inch inch and works prefect
Why does it have to be tested to 6 bar when it’s only going to be around 1.5 - 2 ?
@underfloorheatingsystemslt4824
4 жыл бұрын
Just to make sure there are no leaks, normally 24 h. Our pipe is 10 bar and 95 degree C temp,. High quality.
Is this saying it is 70 day drying time for a 50mm screed?!"!
@underfloorheatingsystemslt4824
4 жыл бұрын
1-2 mm a day
@daiboy8076
4 жыл бұрын
@@underfloorheatingsystemslt4824 Thanks for the prompt response - when would it be ok to walk on
@underfloorheatingsystemslt4824
4 жыл бұрын
I would check with the screeders.
2 months lol 😂
@simonbeckford3025
4 жыл бұрын
69 days is more than adequate sir..
soo expensive. id rather 100000 feet of water hoses.... id rather simply install a normal heating. srew that. and what if it BRAKES???
@goodbyetothepeople92
5 жыл бұрын
Alex S what if you learnt to spell?
@strangedays4
4 жыл бұрын
Do whatever you feel is best