This works perfectly. I recently bought the Kobalt multitool and grout blade. I couldn't believe how easy this was compared to manually scraping. I put this job off as long as possible. It was much worse in my mind until I watched the video and tried it. You can do over a foot per minute nice, clean and deep. Ready for new grout. Nicely done and thank you.

@khgriffi

2 жыл бұрын

were you just changing the grout color?

As an electrician that does strictly remodels this is an absolute essential tool. kzread.infoUgkx0vyBwjtx9GGOuiqUVT2sRoYqmDoNT_RI Being able to precision cut any material with a light weight tool is priceless.I upgraded to this Dewalt 20v from a competitor's 12v. The Dewalt 20v is just as light as the competitor's 12v. I am extremely pleased with the overall performance and battery life of this tool. As far as oscillators go, they just aren't very ergonomic tools. The dewalt oscillators have an offset handle that do make them somewhat more ergonomic than the competitors' oscillators.

Just a thought. I think I would use the tool turned around, so when your viewing from the top, it's much clearer. Great videos.

@alfredovelazquez2916

3 жыл бұрын

He is just recording a video

Good tips, great beard. Feel more confident about tackling a re-grout job at the local scout hut

thanks so much for such a to the point review!

Thank you very much good sir. Just bought corded tool

In the mudroom I have a wooden base board and tile. The guy that worked on the tile grouted the gap between the wooden base board and around the dooar (big gap between entrance and tile) but because its and old house it cracked and sink in some areas. Plus he did not seal it and I have stains all over. What do you recommend to do with that gap, take the grout out and put something else? Do you think I can apply another color, a darker one over the old one?

Where is that cross hatch fabric tile sourced from? I can't find it anywhere and want to match the theme of my house for a bathroom remodel.

You should find an oscillating tool with a stopper attachment. This will save your water proof membrane that is behind your tile. Set your depth to 1/2 or 3/4 the tile thickness.

@0617kitty

2 ай бұрын

Thank you for your advice. I was wondering if an oscillating tool would cut too deep, then it cut through the membrane. Now I can have peace of mind using one.

Can u use the multi-tool to clean out thinset after removing clips in preparation for grouting? Same blade?

Is there a guide attachment for the oscillating tool that will assist in preventing you cutting too deep ?

Would you recommend wetting the tiles line when grout removing from the floor?

I've never had to remove grout and I hope I never do but good video. Nice to see it done with both methods.

@HomeRepairTutor

7 жыл бұрын

+J Parra thanks, it' can be messy if you do the entire shower surround. Admittedly I'd think about just replacing the tile at that point but sometimes that's too costly

@streaky81

7 жыл бұрын

It's one of those things you only ever do once, it's usually easier just to strip the tiles off and start again :)

@BillyBob-ep7em

5 жыл бұрын

Martin Nicholls I’m facing a bathroom countertop that needs the grout removed and replaced and I think you’re right. Rip it up and lay new stuff.

Nice video buddy. really helped me..off course I bought he Dewalt tool :)

Great tip...power tool for big job

Thanks for this!

What options do we have for a bunch tiles that are spaced less than 1/16". I have to do my tub surround and am not looking forward to using a razor knife to get into those narrow spaces!

Thanks so much!

Any tip on how to fix floor tiles that turned into partial drums? - No spare tiles (spare tiles cant be sourced either) and only part of some tiles have turned into drums, so wonder if there's a fix to this without actually removing and replacing the tiles?

Thank you

Note, you can also install the blade with the straight edge facing out, so that you can get in right next to the wall

@HomeRepairTutor

6 жыл бұрын

Thanks N Blackmore for adding that tip. I've done that before in tight spots and it works great.

i am super happy with my Dewalt multi tool, less money than the Fein, and does the job.

Thank u

thanks for video. blades can be pressed/snapped on without flipping lever to unlock. snap on then flip lever to eject. lever only used for removal.

@HomeRepairTutor

7 жыл бұрын

+lawxr6eBay yes, you're correct

How deep does one cut? What is the probable backing underneath floor/shower floor versus wall? Maybe I'm overthinking this.

@dryan8377

7 жыл бұрын

You will cut down to the thickness of the tile+ add a little bit. No harm no foul if you score the backer board, that stuff is really strong.

Thanks for video. Quick question. I have a half inch grout joint that sits between the tub and the tile that needs to be replaced. The silicone wore away and water got underneath and behind the grout. When I press it, it moves a bit so I figure it's time to replace it. What kind of grout removal bit/blade would I use for the larger half inch grout joint? Thanks in advance.

@konanamegakure4342

2 жыл бұрын

Uhhh if you have water leakage behind it wouldn't you remove whole lot, water proof and re do?

Hey! Cool video.

Whats the tesseract to Keep it from scarring the tile.

Oh my bad what sander to remover hardened mortar on the tile or the full tesseract to removing the mortar for tile to prevent scarring

Just had to remove grout from huge back porch used an angle Grinder bedside it was going to take forever otherwise still came out clean but dust is no joke

What is best ..multi tool head ?? To remove tile glue grout ...

Nice 👍

Where from get grout tools in united Arab Emirates.sharjah

In your personal opinion what other brands of power removal tools You recommend that make the job easier & fast ....????? Thanks.

@HomeRepairTutor

7 жыл бұрын

+ZOMBIESCAPCOM1 my experience is with Bosch and Fein, both are great tools

Yeah, I have the pain staking task of re-grouting. What do you think of the Dremel oscillating tool vs the one your using?

@HomeRepairTutor

7 жыл бұрын

+snakemonkey555 the Fein is solid and my favorite oscillating multi tool. It has plenty of power to chew threw grout with the grout removal blade

@snakemonkey555

7 жыл бұрын

The Fein is solid BUT also very expensive. What are your thoughts on the Dremel MM30-3? It retails for about $80.

Have you ever used a Dremel for grout removal? I wasn't sure but it's light and seemingly more agile so you don't scratch the tile? Thoughts?

I've used the hand tools, they jump off track and will scratch your tile. That is if you aren't steady with your hands and have arthritis!

Fun fact - The Fein company invented the oscillating multi-tool and that is why some people called the Fein tool

can I use the multi tool if I have a much wider grout line?

Hi! I have an issue, my wife and I installed glass mosaic backsplash tile, in our kitchen...but the thinset has seeped through the front and sides, and is now hardened there. Do you have recommendations on the best way to clean this out?

@qreqorious

4 жыл бұрын

Try a razor scraper

I grouted on top of grout, and now need to remove just the top layer. Would the hand held be my best bet?

@HomeRepairTutor

5 жыл бұрын

where's the grout, e.g. shower floor or shower wall?

@PaHardcore4life

5 жыл бұрын

@@HomeRepairTutor shower wall

Hey Jeff, the hand held usually doesn't work for me when the joints are narrow :( It's one of those jobs I really don't enjoy but it's on the "HONEY-DO" list. BTW....First! Lol!

@HomeRepairTutor

7 жыл бұрын

it's not my favorite project either, super messy when you take out a lot of grout. But the multi-tool makes it way easier. Right on, being first today!!!

@snakemonkey555

7 жыл бұрын

Home Repair Tutor Yeah I know. BTW...Second, hahaha!

@HomeRepairTutor

7 жыл бұрын

+snakemonkey555 you're on a roll today

@snakemonkey555

7 жыл бұрын

Home Repair Tutor Just in the Holiday Spirit!

@lilace562562

6 жыл бұрын

snakemonkey555 they make cup brushes for the drill spray bottle with hot water the drill in lowest setting

so what happened that your removing the grout did you not like the color?

@HomeRepairTutor

7 жыл бұрын

+Flores 828 no reason in this bathroom, it's urethane grout and can be filled in no problem. I removed the grout just demonstrate the tools 👍

@Flores828

7 жыл бұрын

Home Repair Tutor o ok. im thinking of getting the fein 18v multi tool but idk how good their battery platform is. Are you considering on making a video review on it

@HomeRepairTutor

7 жыл бұрын

+Flores 828 I'm happy with the 12V but hopefully will get my hands on an 18V soon. What type of work are you going to do with it?

@Flores828

7 жыл бұрын

Home Repair Tutor i usually use it to do drywall cutouts baseboard cuts or woodwork that needs smalls cuts. i have the ridgid multi tool which I really like the removable heads. but was thinking of purchasing a back up multi tool

I dunno. I mean if your really in a financial bind or are extremely powerful adverse, I can see why you would get the hand manual one. But honestly the multi tool option is like 2000x faster and easier

How much would that cost me to hire someone to regrout my shower?

@king49334

5 жыл бұрын

A lot

WTf I was watching removing Gout videos. When I moved to the next, I thought this is a comedy with those tools 😆

I see you damaged the tiles with the multitool. Tha's my biggesst fear...

@Chris-fe3dn

3 жыл бұрын

I agree! What is the value of the multi-tool if it is just going to chip the edges of your tile. Now you have to re-tile. You can clearly see the tiles that were chipped by the tool in the video. I wonder if all of the grout attachments would chip the tile like that.

“As you can see, this is a clay based tile.” I did nothing see that.

The link to your home repair tutorials comes up with Error 404

@HomeRepairTutor

2 жыл бұрын

thank you, I just fixed it 😊

Unfortunaltley you chipped some of the tile you. Wed a thinner place for 1/8” joint

What are your impressions of the Regrout Tool from Intertrk? m.kzread.info/dash/bejne/hK13ubezeKvAmdY.html

blades on backwards. ....

@HomeRepairTutor

7 жыл бұрын

+The Talking Donkey this is the Starlock system, it's on the correct way because there's only one way to install it

Need to buy a shop vac too? Nope - fail.

I can see you have no hands on skil at all.

Useless product & waste of time.