Thanks for these great videos! I will be doing the same procedure soon to my Crown Vic

Another great video

I need the video for when the bushing studs start spinning

I have a stud that free spins and allows the sway bar to move. Cant get into the frame to hold and or replace studs.

@welfareorphan

Жыл бұрын

Mine did the same so I used a Dremel to cut it off.

@lawofliberty3517

Жыл бұрын

@@welfareorphan after buying new bushings, I took the old ones off, the adjacent bolt came out and the stuck one fell out when I wiggled the bushing.

@welfareorphan

Жыл бұрын

@@lawofliberty3517 my bad. I was talking about the sway bar links. Thanks for the heads up too because I'm doing the sway bar next.

@lawofliberty3517

Жыл бұрын

@@welfareorphan did my endlinks earlier this year. Upper & lower ball joints, shocks all around, sway bar bushings have been done also. Rides noice now. Going to save up for a complete ADTR suspension kit and do it next year hopefully.

@welfareorphan

Жыл бұрын

@@lawofliberty3517 my lower ball joints were bad. I took them off and noticed both upper and lower control arms bushings were bad. So instead of pressing out the joints, I'm taking off everything. I already bought TRW upper joints and sway links. I had the TRW lower joints but sent them back and decided to get all TRW upper/lower control arms with the lower joints and bushing already pressed in. My tie rods are ok for now.

Hi Ahmed did you use motorcraft parts for your sways and ball joint replacement

@ahmedaltowaileb

Жыл бұрын

Hi, for the ball joints, yes I used Motorcraft For the sway bar, no

@WhoKnws

Жыл бұрын

Moog is a great brand too

What size is the bolt nut on bottom swaybar link? Mines just came loose

Flip Flops.. I’m done