GOEREND TRANSMISSION: OVERDRIVE SECTION

Автокөліктер мен көлік құралдары

Goerend Transmission Overdrive Dis-assembly and Re-assembly
Check back for additional video with information
**This is approximate information only and may not apply to all transmissions. Goerend Transmission Inc. holds no legal responsibilities for any problems (mechanical or otherwise) caused by following the instructions in this video.

Пікірлер: 25

  • @Ashroyer86
    @Ashroyer865 жыл бұрын

    That last part I think was pretty important from what I've heard, glad you mentioned it. But would be nice to see where you measured that "width".

  • @jimkillen1065
    @jimkillen1065 Жыл бұрын

    Dave has helped me before fix my friends 47re a broken second gear strut . He took time years ago to explain to me how the triple disc convertor holds more than the single back when folks said there was no difference in holding . I guess that's been put to bed lol . I always been a fan of Dave's products.. if I had a automatic I want there products

  • @dieselmakesmehappy
    @dieselmakesmehappy6 жыл бұрын

    Very helpful thanks!

  • @montrosepatriot
    @montrosepatriot7 жыл бұрын

    the 5 disc pack is recommended when overhaulin a 42RE with the stock 2 or 3 discs

  • @HaythamBuKhadra
    @HaythamBuKhadra5 жыл бұрын

    Thank you.

  • @MrPapasmurf1961
    @MrPapasmurf19614 жыл бұрын

    witch trans is this one its just like minebut i dont no yr or witch one it is it has been replaced ty

  • @omarmonzo5426
    @omarmonzo54267 жыл бұрын

    how do you check the clearence?

  • @kenbrandt6104
    @kenbrandt61043 жыл бұрын

    This would have been a good time to show installing the repair shim.

  • @person440
    @person4404 жыл бұрын

    Where do you measure the width of the piston at when selecting the correct spacer. That information is of no use without knowing where you measure the piston at.

  • @andrewjessen764
    @andrewjessen7646 жыл бұрын

    So if you needed to replace just the housing, there is no need to disassemble the internal overdrive section? Sounds like something I could actually do myself if that were the case (I don't have a press). Great video.

  • @sknfjuebc

    @sknfjuebc

    4 жыл бұрын

    Same situation I’m in

  • @AndrewBrowner

    @AndrewBrowner

    2 жыл бұрын

    put me down for the same problem, going to give it a go and just throw the known good parts in a new unbroken housing and hope for the best

  • @andrewjessen764

    @andrewjessen764

    2 жыл бұрын

    @@AndrewBrowner Worked good for me.. I shoved a #2 pencil in the parking paw to get it out. Going on 3 years without an issue. Got my housing from Cascade.

  • @AndrewBrowner

    @AndrewBrowner

    2 жыл бұрын

    @@andrewjessen764 i got the housing off, the park rod stayed with the transmission, ive heard its a pain to get it back behind the pawl, did you just slide the housing on and spin the output slightly to get it to pop behind the pawl?

  • @andrewjessen764

    @andrewjessen764

    2 жыл бұрын

    @@AndrewBrowner Yes I believe so

  • @pedronazario223
    @pedronazario2236 жыл бұрын

    how to align the axis inside

  • @c-low6010
    @c-low60105 жыл бұрын

    Fiber steel

  • @manueltorres1741
    @manueltorres17414 жыл бұрын

    Tengo sin serevsa

  • @felipevalles8041
    @felipevalles80412 жыл бұрын

    does this part can fix the reverse issue ? thanks

  • @Junior-hd2hc

    @Junior-hd2hc

    2 жыл бұрын

    Does urs not have any reverse or did u get it fix?

  • @felipevalles8041

    @felipevalles8041

    Жыл бұрын

    @@Junior-hd2hc mine got some but it feels like is shaking when I applied it, I have to give her a little push to back up , im going to open the fluid pan to see whats going on.

  • @Junior-hd2hc

    @Junior-hd2hc

    Жыл бұрын

    Alright I took apart my transmission, nothing was worn except the OD housing. The snap ring that needs to be pressed on was broken and the clutches werent pressed on. Gonna try and drive it this weekend.

  • @Junior-hd2hc

    @Junior-hd2hc

    Жыл бұрын

    Also when I open the pan I saw pieces of the snap ring that broke

  • @t.c.3027

    @t.c.3027

    Жыл бұрын

    @@Junior-hd2hc saw nothing was wrong?? Betcha that reverse drum was scared something terrible & or band seriously needed to be replaced?🤔...

Келесі