GMC Yukon liftgate stuck and won't open?? I'll show you how to get it open! | I Can Do That DIY
Тәжірибелік нұсқаулар және стиль
Motroized liftgate jammed closed and won't open?? Let me show you how to get it open by manually accessing the liftgate latch. This will work on most 2014-2020 Yukon's, Tahoe's etc. The same basic principal will work for older ones also.
Пікірлер: 14
Finally this explains it very well. Thank you.
@icandothatdiy4007
Жыл бұрын
You’re welcome. Glad it helped!
Did it reset after you opened it, or did you need your replace the latch?
@icandothatdiy4007
2 ай бұрын
It reset and has worked just fine until a few weeks ago. I just barely replaced it.
Did you push it twist it
@icandothatdiy4007
Жыл бұрын
Are you asking about the square piece on the latch? Once I had the screwdriver in I twisted/turned clockwise and it opened the latch
If you had the cover off in the first place, why would you drill a hole in it?
@icandothatdiy4007
8 ай бұрын
Great question. Due to the raised section in the cargo area I could not bend the cover far enough or remove it to get a screwdriver at the correct angle to open the latch. The only way was to drill a hole. I should have explained that better in the video.
I am running over the same case 😢
@icandothatdiy4007
10 ай бұрын
Hopefully this video will help you get it opened
I drilled the hole and did everything like ur showing and still nothing
@icandothatdiy4007
4 ай бұрын
Check out the picture in the upper left corner at time stamp 1:25. If you can get that flat bladed screwdriver in that square section you should be able to turn it & open the lift gate. If the screwdriver is too small it won’t turn. Hopefully that helps. Best wishes
I don't see the big Ass hammer that is typically required on most jobs...
@icandothatdiy4007
Жыл бұрын
It was in the garage but fortunately it was not needed on this job 😄