Yeeeeee, you don't know how much this helps me (and so many more). Thx a lot.

Hi sir I appreciate your work but just want to tell that u dnt have do matlab for getting those plots directly u can plot in cadence itself. After getting all operating point parameter go to results browser there u will find "gmoverid " parameter right click on it u will have option "Y vs Y " select that and click on "vgt" (Vgs- Vth) u will get plot for (gm/Id vs Vov). similarly u can get plot for ft which nothing but "fug" in operating point parameters list.

@hafeezkt1

7 жыл бұрын

Yes, you are correct. I came to know about this feature after making the video. Thank you very much for putting this as a comment here so that others can use. Thanks once again

@satsih8266

7 жыл бұрын

Sir, could you provide video/material for design of common source with current source load using gm/id method?

Thank you very much for the videos. They are really helpful.

thank you sir this video is very help full for beginner.

Thank you so much . Your videos are so help full

excellent and informative video

Hi Hafeez, Could you please make a short video on how to decide/set the W/L ratio of a MOSFET for a given circuit. Please consider a simple circuit and calculate W/L ratio, would be of great benefit for us. Thanks

Thank you so much for posting this video

Thank You very much Sir. I am eagerly waiting for your videos containing interpretation and examples of gm/id method.

@danielsapir1613

5 жыл бұрын

Vishnu Teja Desai , you can watch my video just check my channel

thanks for uploading these videos!!!

Hi sir i appreciate your work it is very helpful for me and i am eagerly waiting for your videos for examples of gm/id method

@danielsapir1613

5 жыл бұрын

Hi Maolin, I've followed Hafeez video series and upload an example of my own - kzread.info/dash/bejne/h4mdzbCGcaezmqQ.html

Sir, could you provide videos for design of op-amp using gm/id method?

Thanks for this.....

Hi Hafeez, Thanks so much for these informative series of lectures on gm/id. Can you please upload a video to interpret the graphs we have obtained in this series. Also, how this method would be used for designing circuits. Thanks so much.

@danielsapir1613

5 жыл бұрын

Hi salil, I've followed Hafeez video series and upload an example of my own - kzread.info/dash/bejne/h4mdzbCGcaezmqQ.html

Thankyou

How do we consider noise parameter or minimization of noise using gm/id technique? please give an example so that we can implement it.

Thanks Sir...

Hi Hafeez, I would like to know what is the correct value of VDS to obtain the correct curves for each transistor in a 130nm CMOS, where the maximum voltages for these transistors are 1.2V? Thank you !!!

Sir i am working on transimpedance amplifier and not able find the w/l or bias current or voltage for making mos in saturation. How and from where can i learn this.

Hi Hafeez, I went through your tutorial and I am unable to find your videos for the hand calculations and interpretations for the same. Could you please lead me to that video. Thanks. The tut was amazing.

@danielsapir1613

5 жыл бұрын

Hi Vinay, I've followed Hafeez video series and upload an example of my own - kzread.info/dash/bejne/h4mdzbCGcaezmqQ.html