Ya know the feeling of driving away from a workshop asking yourself if you paid for a genuine problem or your lack of knowledge.

Have you installed any other brands of glow plugs? I replaced mine with ngks and it seemed to of not used all of the thread compared to the geniune ford ones. Px2 ranger. Its all running sweet but..

Your vid started in the middle after you have removed the manifold and others, poor vid

Thanks a mill for your wonderfull content. Just finished changing my 2015 xls ranger glow plugs following your videos. Its back on the road. I freaked out a bit when it started the first time then cut off. Tried to restart several times with no luck. Somehow I got the idea that it must be fuel, so I started pumping a bit on the accelerator and it worked. 🇿🇦

I’m experiencing low power at low rpms for my 3.2 ranger, this is after my intake manifold and Egr was cleaned. It was fine for a month or so. Now it’s really low power. Could it be the glowplugs? No check engine light on as well though

How much does it cost

Hey Killa....I just want to say thank you for all of your uploads. They are really helpful. Much appreciated 🙌🏻👍🏻

Thank you for sharing your experience on this topic I have followed every step of the way with your process from cleaning and replacing the glow plugs on my Ford Ranger 2015 PX2 🤙🏽👍👍 it’s working perfectly the engine performance is just what I expected God bless you mate keep up the Awesome work 🙌🙌🙏🙏

Thanks for the video. How long would the whole procedure take normally if replacing all?

Is there a millage recommendation for changing the glow plugs? Thank you very much.

Got a set I need to do next week thanks for the video mate 👍

Great video brother. Thank you very much

Thanks for the great video, quick question, I’ve been told sometimes the glow plugs will be seized. If I get to taking them out and they feel stuck what do you recommend? A few people say wd40, but in not sure about putting any substance down there. Would you recommend using anti seize on the new glow plugs when installing? Thanks

Hey mate according to the Haynes Manual torque setting for the glow plugs is 12nm.

Thank you so much for the great video!!

Hey mate do you know if cylinder 2 glo plug can cause the car to go into limp mode if faulty? Cheers

Hey mate, do you have your own workshop? Just wondering if my glow plugs go bad id rather go to you than have the displeasure of taking that POS inlet manifold off again!

Can carbon build up cause stalling?