Thank you for the clear video and instructions! I had a repair guy come out twice, and he wanted to replace the main board and the control board at over $400 (at which point I could get a new dishwasher), but my dad thought it was the sensor and sent me the part and your video. I have petite hands, so I was able to pull out the dishwasher about 6 inches (after turning off power of course), and reach it through the side. It worked! For anyone having the issue, I was not getting the H20 error and all diagnostics were coming back normal, but it would periodically get stuck on drain cycle, at the beginning or in the middle of the cycle.

@myappliancefixed

Ай бұрын

I'm glad it's helping. Some of repairs are very easy if you know what to replace;)

Thank you for taking your time to make this video, I’m working on the exact same model, it would not fill with water / it’s only two years old- I removed this part and I saw a lot of slime inside so I am going to purchase one of these today and give it a shot / I almost purchased a control board because I thought it was faulty- I really appreciate you 😎🏁

@myappliancefixed

5 ай бұрын

Thanks for your kind words I really makes my day I know these videos going to help others because these issues come back over and over on the same model usually

@aarond725

3 ай бұрын

@@myappliancefixed I watched about 20 other videos but this was the one that led me to the solution - thank you! I just cleaned mine out and did not need to replace it.

Pretty sure this is the problem on my two year old GE Dishwasher that is stuck on drain mode when I push the start button. Got a replacement coming. My research for a DIY fix says the other possible issue could be the control board. I go with the easy fix options 1st. Thanks for the lesson. 🙂

Thank you that worked

Likely the same problem on my 2 year old GE Dishwasher that gets stuck on drain mode when initiating Start of wash cycle. My research for a DIY fix says if that does not fix it, ... then try a new control board. Thanks for lesson.

What happen if diagnose H20 replace the pressure swith still same diagnose what is the other problem

@adamkalon7584

8 ай бұрын

Control board

@myappliancefixed

8 ай бұрын

If it's filling and draining properly and have a correct water level I would say it's the problem with the control board. Then if there is no water in it, maybe water valve. I will try another pressure switch before putting a new control board in check the connectors. Sometimes mice eat the cable and could be no connection between the control board and the precious switch. I've seen that a lot. Good luck!