Finally a video that shows how to actually take these measurements. To the point! Thank you!

Just wonderful… really makes a lot sense…. Great video

Awesome learnt GD & T well😄

Great video!

Mind blowing 😮

Nice Video

Best video i ever seen thank you

at slide 2:30, if the dial bore gauge is at a different angle, isn't it measuring the "hypotenuse" length variation? shouldn't the dial gauge mounted horizontally?

@ENGINEERINGEXPLORED

2 жыл бұрын

Yes

@danielpotenciano7753

Жыл бұрын

You are right!!! also when they are triying to measure cylindricity is in that way, cilindricity is a 3D dimension and in internal measure, not external, they are measuring total runout.

❤

Great ji

Good

very helpful

This video made my day! Thank you so much for creating this video... this is the best teaching tool I have ever seen... Reading from a book does not teach everything... Please make more videos to show different ways of all 14 basic measurements...

@ENGINEERINGEXPLORED

Жыл бұрын

Thank you

Amazing 👍

Actually Flatness is checked wrong, part needs to be on three points above the surface plate, (like gauge or 1-2-3 blocks) otherwise you are checking parallelism to the surface plate because you are fully resting the part on the surface plate. See the GD& T Y14.5-2018 specifications for proper setup of flatness. I usually test this on the underside first with a dial test indicator and then the top to check both surfaces for flatness in my metrology lab. Several mistakes here, including measuring perpendicularity, dial indicator has to be 90 degrees to the part, no angles allowed otherwise cosine error.

👍

Need to be slow and brief details .. please hurry...

How to check internal dia with this dial ?

Able to learn fastly than reading from a books

Thanks for the video , but i think at 0.54 you are checking parallelism not flatness .

@mscscambodia

6 ай бұрын

Yes this is parallelism check not flatness at this point in the video.

Give pdf on link for study more & procedure

Hi it is verry nice. Can you Give me the parts and assembly for Inventor or step or Solidworks pleace

@ENGINEERINGEXPLORED

Жыл бұрын

I missed model. When I found I will sent

Concentricity missing 🤔

@ENGINEERINGEXPLORED

7 ай бұрын

Circularity AND Concentricity 2:09

Need explanation....otherwise this video is not worth

@lukgreg3717

2 ай бұрын

😂😂

Good