Your videos are a joy to watch. And so relaxing too. New sub right here. Great work.

@DarthRageReviews

4 ай бұрын

Thank you and you’re welcome. 👍🏻🫡

please make sergeant sinkers helmet (realistic style)

@DarthRageReviews

4 ай бұрын

That’s a good suggestikn

Great job on this! I just printed the same helmet and I've started the prep process. I wanted to ask about the placement of the inner and outer buttons, that allow the helmet face to open and close. Galactic Armory didn't specify how and where to place them exaclty. Would you mind sharing the details ?

@DarthRageReviews

2 ай бұрын

I think I have an earlier version of the helmet, there was no inner and outer buttons, just a round tab on the visor that fit into a hole on the helmet on each side.

@davidgaston7334

22 күн бұрын

Did you ever figure this out? Just finished printing all the pieces myself and want to ask before I break out the dremel lol

@DarthRageReviews

22 күн бұрын

@@davidgaston7334 I think Aaron has updated the file since I did mine. I just popped it on, no cutting required.

I’m putting this same helmet together now. How did you assemble the visor hinge?

@DarthRageReviews

22 күн бұрын

I may have an earlier version of the helmet, mine just snapped right on the two pegs

@its_chup

21 күн бұрын

@@DarthRageReviews Ah I see, I may have to get some hardware then to get it to fit. Thanks!

@davidgaston7334

12 күн бұрын

@@its_chup I just figured it out, it's kinda confusing. The outer bolt ofcourse goes on the outside of the visor, but the inner bolts need to be reverse of what you think they go if that makes sense. They go into the other part of the helmet from the outside. Trying to explain it is hard but it shouldn't require any hardware. HMU if you can't figure it out since galactic armory doesn't seem to care much lol.