Thanks Brad

I remember that from the pencil sharpener project. It's simpler to set the correct ratio with the number of teeth instead of degrees. Of course if no one mentioned it, we'd all be using degrees until forever.

Beautiful

GREAT!!!!

Great tip Brad. I didn't know that was possible 🙂👍

WOW, great video, nice trick with the teeth count, I didn't know that, thanks for sharing...

Simple, but very effective tip 👍🏻

I still cannot figure out why you have such low subscription numbers. Best regards.

@bradtallis8968

9 күн бұрын

I probably should "promote" more, but I'd rather create videos than "market" them. :) But, share my channel with your friends, co-workers, etc. That will help drive the numbers up. Thanks for caring!

And how do I do that kind of joint?

@bradtallis8968

9 күн бұрын

@eedesign878- Those are "As-Built Joints". Basically, if the parts are already "put together", you create an as-built joint. You would click the shaft component, then the wall component, then select the hole in the wall that the shaft rotates in. You would select "rotational" as the joint type.

@CraigMoynes

7 күн бұрын

@@bradtallis8968 Might be a good topic for a future video :) Loved this one, thanks!