Dude this was actually a good video!! Thanks

Thank you. 🎉. Good teacher 😊

Thanks for such a direct and simplistic video

Thanks for quality content.

great video, thanks for sharing your knowledge.

Thank you for your great detail, video

thank you good video i use it to replace my bushings and spring leaves

Is alignment needed after replacing the leaf spings?

I just replaced my front Springs and bushings with the same brand Springs in this video Triangle...and did it all by myself

@owneroperatorlife4380

Жыл бұрын

I am thinking about doing my own.

How are the “two” leaf springs aligned if “one leaf” moves? I see there is a bolt in the center. Would removing that bolt allow me to straighten the “leafs”?

Another good video bro. Thanks. Have question do u know is there double leaf spring for new 2019 freightliner Cascadia? Mine has one spring and its rough on bumpy roads.

Hello Mr Now.......👌🏿

Where is a good place to buy front leaf springs for a 2001 Freightliner FL60 26 ft box truck?

what kind of jack stands are those?

Hi I have freightliner cascadia 2016 automatic 9 To 10 go to netural I charge 1speed sensor 2.Transmission positioner compl 3.control unit AND 4.clutch still problem isn't slove can you fix me truck or some tips pls?

Do you know what causes the ck eng lite stop eng lite and oil lite when coming to a stop and pushing in the clutch and sometimes when turning slowly? Then it goes away, temp is ok oil pressure is ok

@franciscoamayaYT

6 жыл бұрын

Oil pump o-rings and suction module

Hi I have 2016 freightliner cascadia problem when I drive 9 TO 10 gear go to Netural I change 1. speed sensor 2.Transmission positioner compl 3. Control unit AND 4. I CHANG CLUTCH STILL PROBLEM ISN'T SLOVE CAN YOU GIVE ME SOME TIPS pls?

Can this problem make the cabin vibrate? I have a vibration on my cab. Replace motor mounts and cab bushings also new clutch.

@davidortega7957

4 жыл бұрын

CHECK THE TIE ROD ENDS AND THE "U" JOINTS AND THE CARRIER BEARINGS

Do you know the torque specs for the bolts

Can the bushing be replaced or it has to be the whole spring

@franciscoamayaYT

5 жыл бұрын

The bushings can be replaced but it is always better to replace the whole spring.

How about the leaf springs on the drive axles? Do you recommend replacing the whole leaf springs versus just the bushings?

@franciscoamayaYT

4 жыл бұрын

Yes, replacing the spring is better. But they don't break so easy. Just with the bushings is fine to save $

@thereviewer4173

4 жыл бұрын

Francisco Amaya Thank you!

Green beret , McAllen, Tx

Hola ,como saber cuando los muelles delanteros están vencidos

Where is your shop, buddy. So I can take my truck to be fixed..

@kikemoran7

3 жыл бұрын

Fontana CA

you can still install the two jacks the same way without removing the bumper.

@thereviewer4173

4 жыл бұрын

Wouldn’t that be dangerous as the engine weight could make the truck lean forward?

@mastermechanicfelipe4641

4 жыл бұрын

@@thereviewer4173 many ways to skin a cat

Hola, buenas tardes, tiene algún video de como cambiar los kingpin en un cascadia 2011? Gracias

@franciscoamayaYT

4 жыл бұрын

No, todavia no.

Where you located ?

Where's your shop?

Is it better to take the tire off or not next time can you show all the proses I just mine and I had problem to aline it back

@franciscoamayaYT

5 жыл бұрын

You need some like a strap to pull the axle back. It is normal that it moves like 1 or 2 inches.

@ralphsnow2337

5 жыл бұрын

Leave them on they hold the axle assembly up

On my 2015 freightliner cascadia it has a vibration which I have taken to several mechanics and have spent over 7000 to try to have fixed and it still vibrates especially when loaded and at higher speeds. We have replaced drive tires the hub have had tires balanced several times have had it aligned had all suspension parts checked and anything needed fixed and replace. Yet the driver side is still a quarter inch lower than left and we have recently noticed the driver side leaf spring has play where as the passenger side is fine. So I am going to have driver side replaced. Do you think I need to replace the passenger side too? Do you think there is anything else that could be causing the vibration? They have also checked the frame and the frame is fine.

@franciscoamayaYT

7 жыл бұрын

+Iaven Ziad Odanodlam I recommend to replace both leaf springs at same time, it could be possible that you leaf springs bushings are not insolating the vibration for the road. Do you know where the vibration is coming for? The steering wheel? Under cab? Around the cab? Rear area of the cab? Or all mentioned above?

@diaznevai8624

7 жыл бұрын

Francisco Amaya thanks a lot for your quick reply and your advice Francisco I will get my 2 sets of leaf springs replaced on our truck hope that will minimize the vibration

@diaznevai8624

7 жыл бұрын

Francisco Amaya most of it the vibration feels on the steering wheel but yeah it's Shaks the whole truck it feels ,we balanced steer tires put new steer tires put new carrier bearing put new f shocks on the steer axle ,even balanced the drive tires thinking that could b the issue, and it steel vibrating it feel more intensive when it's loaded I don't know why and when I'm driving down the hills. At speeds between 50 and above the faster the speed the more intense the vibration, I took it to a mechianic couple weeks ago and he lifted both drives and put the truck in gear and for some reason it was doing little shaking but not so bad then we took all the drive tires off and there was no vibration at all we even disconnected the drive shaft where the carrier bearing is and no vibration was found, it's so frustrating that no body can find the issue

@diaznevai8624

7 жыл бұрын

Francisco Amaya we took it to the freightliner shop @ 1st they said it was the lead spring s on the driver side that were worn out they said that for some reason it was putting pressure on the steering gear box and was making the suspension shake and then they called me next they and said that that leaf spring was still good that they found a different problem that the wheel bearing that was little bit out of round so they replaced that costed $1300 and didn't solve the problem,so I took it to other mechianic this time he checked everything as other mechianic's did before including drive line u joints king pins all that stuff he said that everything looked good except the driver side spring leafs he showed me how when I rock the steering wheel with the engine running how the axle on that side moves back and forth,and the. he did some measurements on the frame ,from the top of the leaf aping to the bottom of the frame on the steer axle the the truck is lower 1/2 inch on the driver side where the bad leaf springs are , so this time I guess we will replace the 2 front sets of leaf springs and the rear shocks and the leveling suspension valve i'm hoping that will help with this issue,....if u think abt anything else that could possibly be please let me know I would really appreciate it ,thank you

@diaznevai8624

7 жыл бұрын

Francisco Amaya So Do you think after doing all the work we have done so far by replacing the two leaf springs that it will stop the vibration or do you know of anything else that may cause it? If it's easier to respond to me by email it's Nevai.diaz@gmail.com I'd leave my phone number but don't trust online prowlers. I've been watching your videos for awhile now and you know a lot about these trucks and I trust your opinion and am tired of taking it to places wasting valuable time and money guessing at this.

How much it cost to replace leaf spring, I have 2011 Cascadia, and how many days..please

@thereviewer4173

5 жыл бұрын

Bilal Agha Mine cost a little over 1k. The dealer would probably charge over 2k. Make sure you get OEM leaf springs. I got some non-OEM and it looks like they are not holding well.

@smithsmith1000

5 жыл бұрын

Cost me $550. Did it myself.

@fernandosalas6402

5 жыл бұрын

To reforce the some springs. Is less cost

Do I need an alignment after ?

@franciscoamayaYT

4 жыл бұрын

Yes, it is good to do an alignment after

@amilcargonzalez167

4 жыл бұрын

Que cuesta ese trabajo con todo y partes

🆙️🔝Salute General bless🆙️

Oil pump orings?

@bigmattus

6 жыл бұрын

That’s what I thought thank you so much for what you do. I have it getting overhauled right now

@franciscoamayaYT

6 жыл бұрын

I have a video about it Here is the link kzread.info/dash/bejne/f32XuNaCmcyoZrA.html

Need to replace that whole damn truck

i dont remove the front bumper, that's too much extra work

Why you removed the bumper and finders. You add to much work for nothing . I replaced them one year ago at loves truck stop in Dickson TN they don’t remove nothing and very easy

@r.b.8626

4 жыл бұрын

People do different things in different ways for different reasons . Take the knowledge and do your own thing . We’re all gonna do the same thing in different ways . Humans ...

Olds springs for news springs ...in mex just to reforce the some Springs and ready

Man send me your address now