You could just use a suitably rated SSR solid state relay and enable it from the old spindle DC drive. Cost me a little over £5 ($7) + a bit of mains cable. Works perfectly for automated start + stop.

@TheCrawlspaceCraftsman

10 ай бұрын

Thanks for commenting and watching!!

those are cool!!

@TheCrawlspaceCraftsman

Жыл бұрын

Thanks man!!! I love it! Super glad I got this.

Great job in explaining how it works. Just got mine and was going to install it this next week. The shut down between changes in carving locations would have made me stop the whole thing mid way. Thanks for explaining that in the video. I do have a question on the board shown in the video that goes down the left side of the machine. Was that for keeping the shavings out of the belt? How is that working for you and what size did you use? I keep cleaning out the channels as the cuts are being made but if this board works it would keep me from having to get close to the machine as it is on.

@TheCrawlspaceCraftsman

11 ай бұрын

Thanks so for the comment! Yes…. I made a simple L to hang over the left side of the rail and it helps substantially! I found that the left side gets a lot more dust build up than the right side. I made some from scrap wood but you can almost use anything like cardboard or corrugated board. I highly suggest using compressed air to blow out the channels regularly. The cover makes a huge difference!

@viffs.3554

11 ай бұрын

⁠@@TheCrawlspaceCraftsmanThank you.

Any updates regarding the router switching on and off during the program 'rapids'? Thank you.

@TheCrawlspaceCraftsman

7 ай бұрын

The short answer is no. I switch so much between the Router and Laser I don’t hook it up. I’m going to have a dedicated CNC machine soon so I’ll definitely hook it back up and see what happens! Stay tuned because I’ll be reviewing a new FA machine in just a couple weekends!

question, those rubber belts on the rollers, how often do they have to be changed, the other machines didnt have them?

@TheCrawlspaceCraftsman

Жыл бұрын

As long as they’re tensioned correctly you shouldn’t have to change them that often. It also depends on how often you use the machine.

@mtz3843

Жыл бұрын

@@TheCrawlspaceCraftsman once i get the machine ill be using it 5 days aweek

@TheCrawlspaceCraftsman

Жыл бұрын

@@mtz3843 just make sure it’s not over tightened. Too tight will cause too much fiction on the wheels and track causing your Y axis to stick. Too like and it’ll slip which I turn can tear them up.

What software do you run with this machine? Have not purchased a machine yet, but I'm looking into the software.

@TheCrawlspaceCraftsman

6 ай бұрын

I’m a simple guy so I really like Easel for CNC and LightBurn for the Laser.

Did u know why router shutdown between passes?and what type is the relay

@TheCrawlspaceCraftsman

10 ай бұрын

Sooooo….. I haven’t really looked into it but I have a feeling it has to do with the Laser $31 setting. I think (don’t quote me) it’s acting like the laser and shutting on and off between passes. I’ve been lasering a lot lately so I haven’t messed with the switch box yet.

@mohammedalsamin2299

10 ай бұрын

@@TheCrawlspaceCraftsman ok thanks, mine should arrive this week will see what happens