Ford Fiesta tdci won’t start, crank sensor
This 2006 Ford Firsta 1.4 tdci failed to start. Engine turned over but it wouldn’t fire. Code reader pointed me to the crank sensor. Also when looking at the live data the engine speed stayed at zero even when turning the engine over. Fairly easy fix in the end. Also don’t forget to clean the back of the pully wheel.
Пікірлер: 48
Hi. I have the Bantam bakkie with the same engine. It won't start either, but does start with CRC and dies after it runs out. The code reader can't pick up any codes and diesel is going thru as I loosened the injector pipe and it does get fuel. Where is the diesel pickup censor? Is it the small one connected on the plastic pipes?
Çool...same problem...I'll have to get a ñew one tomorrow
You don't have mate to remove anything!!crankshaft sensor is easy to remove without removing tyre ecc..but anyway thanks for the info
Where is the camshaft sensor in a 1.25 zeroed petrol?
This was exactly what I was looking for after searching 100s of KZread videos and googling. My 2014 Ford Figo 1.4 Diesel TDCI Titanium has starting problems and one of the so called self motor expert told me that the Bendix was bad. The guy repaired it and installed the self motor. But after this also the engine won't start. The flywheel was not fully engaged and it could not rotate. May be i will try the same in my car as well. One question, you unplugged the power socket near the flywheel and still it started. What does that power plug used for?? Thanks for the nice Video.
Code P0340
Hi. So what was the initial problem, did it try to turn over or just nothing at all? My 1.6TDCi won’t try to turn over but all lights on dash, radio, lights etc work
i have a power loss problem, with an indicator light (exclamation mark). I changed the diesel filter, air filter, spark plugs and I also changed a brown relay located in a black box behind the battery, but the problem is still present.
My car has crank non start same issue but no fault codes have you any ideas - I’ve changed fuel filter pain to bleed , cleaned fuel tank Thanks mate for the video what power gun do you use to take off crank pulley I need to buy one - I always lock flywheel to get pulley bolt off but is a faff . Cheers
the location of the preheating relay please ?
I have changed sensor three times but still getting P0366 periodically (every 5 or 25 days). What could be the problem? Car wont start when it happens.
Is possible to change this sensor without take off the wheel (pulley) and belt??
I change my timing belt. After change Tha timing belt my car not starting and show me camshaft and crankshaft sensor not working properly. Pls can u tell me what is possible
Hi, how did you understand where the problem was, thanks.
My fiesta doesnt start after swappjng the Belt so this might be the problem
Hi! It's been a while since this vid was posted but still going to ask anyway. I got the same engine 1.4 tdci, 2004 model. Engine works, rpm picks up nicely when stationary but when it idles for a couple minutes (very low chance of it happening) or when I put it in gear and try to move engine dies, getting a P0337 code when I check via obd. How can I make sure it is the sensor causing this issue? I'm in a very small town with not very good mechanics around so I have to diagnose and fix this myself sadly. Any help would be appreciated
dont think the belt or pulley needs to come off for that
The crank sensor will come off without doing any of that !!!!
What sort of joke, takes the parts off before starting to video 😴😴😴